Does the Draw Tite Hitch part # 24907 Require Drilling to Install on a 2013 Nissan Sentra
Published 01/27/2015
Products Featured in This Question
Question:
will i have to drill any holes
asked by: Larry
0
Expert Reply:
Yes, the Draw Tite Hitch part # 24907 that you referenced does require a little bit of drilling to install.
For more info on the installation of this hitch check out the link I attached for the instructions.
For a similar hitch that doesn't require drilling that is confirmed to fit your vehicle you would want the Curt Hitch part # C11349.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Hitch for a 2015 Nissan Sentra SV
- Q&A: Possible To Tow U-Haul Cargo Trailer 4x8 Or 5x8 On 2013 Sentra SV?
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Hitch Fitment for a 2024 Nissan Sentra
- Q&A: 7-Way Trailer Wiring Connector for 2011 Nissan Pathfinder Towing Boat Trailer
- Q&A: Trailer Brakes Lock Up when Trailer is Plugged into 2015 Nissan Xterra
- Q&A: Ram Truck Factory Puck System for 5th Wheel Hitches
- Q&A: Trailer Hitch That Fits 2013 Nissan Sentra SV
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: How to Choose a Bike Rack for a Sedan or Hatchback