All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Repair your Lippert leveling system with this replacement hydraulic pump. The 1.2-gal reservoir keeps fluid flowing, while the 4-bank manifold distributes pressure. Pre-wired for easy installation, so you can get back to smooth, reliable leveling.
Replace a cracked or faded switch bezel on your Power Gear leveling system with this black/silver trim piece. Snaps in easily for a quick cosmetic fix. Works on select Power Gear RV leveling system control panels.
Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Wish you had a quick way to swap out your batteries? Well, you do now. Easily slide this tray out of your RV so you can monitor, replace, or disconnect your batteries without wasting time rooting around a cluttered or cramped cargo compartment.
Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.
Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces the prop rod assembly on your Leer tri-fold tonneau cover (631303, 631105, 631286, and 631335) or quad-fold tonneau cover (650400, 650149, and 650320).
COMING SOON! This winch assist for the Jack-E and Jack-It Pro carrier makes loading and unloading of heavy e-bikes virtually effortless. The hand crank operated winch can lift up to 160 lbs.
You roll the carrier into place without strain, easing it out of the hitch and onto smooth ground so you can unload without lifting and get back to the rest of your day.
COMING SOON! Easily move your Jack-It Original or Jack-It PLUS bike rack from the trailer A-frame to your vehicle hitch. Detach the V-Wing carrier section and mount it to the adapter on any motorized vehicle for convenient bike transport.
COMING SOON! The Bump-It receiver adaptor transforms the Jack-It Pro and Jack-It TwinSpin trailer A-frame mounted bike rack models into a mobile solution for the vehicle hitch.