Replace a cracked or faded switch bezel on your Power Gear leveling system with this black/silver trim piece. Snaps in easily for a quick cosmetic fix. Works on select Power Gear RV leveling system control panels.
Replace your RV's awning roller and fabric with a heavy-duty assembly. Fits Solera 20' power and hybrid awnings extending 8'. Includes LED strip sleeve. Easier than replacing fabric alone.
Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.
Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.
A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.
Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.
Replaces the rubber gaskets on your LaSalle Bristol black-water waste valve. Prevents sewer water from slowly leaking out of the valve. Includes two seals for both sides of the valve.
Pipe assembly connects both drains in your dual-basin sink to a single 1-1/2" pipe. Seals included. Made of ABS plastic. Measures 11" center to center.
This 1/2" cone washer creates a watertight seal in your RV's PEX plumbing system. Seats snugly in faucet or toilet fittings to stop leaks and keep your fresh water lines drip-free.
Replaces the stopper in a LaSalle Bristol drains for bathroom sinks. Includes ring seal so you can fill your sink with water without it slowly draining out.
This fitting replaces the 1/4" pushlock to male 1/8" NPTM fitting for your Demco Air Force One supplemental braking system. Straight design allows for streamlined routing of your air line.
Restore safe towing with this 2" ball coupler for your Demco DA70 actuator. Replaces worn or damaged coupler and bolts directly to the actuator housing.
Bolt this locking plate onto your Lippert Helux pin box to prevent the king pin from rotating inside your Demco Autoslide fifth-wheel trailer hitch. Hardware included.
Replaces the fuse holder for your Demco Stay-IN-Play Duo (SM99251 or SM99243) or Air Force One (9599007, 9599019, 9599020, or 9599021) supplemental braking system.
Replaces the 2-5/16" coupler for your Demco Recon Gooseneck to 5th wheel hitch adapter base (DM6021). Provides the attachment point for the gooseneck ball in your truck bed.
Lost a fender on the road or cracked it backing into a tight spot? This replacement passenger's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Lost a fender on the road or cracked it backing into a tight spot? This replacement driver's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Square tube welds onto your trailer. Works with 4" width inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM43KV (sold separately).
Replace the lost or damaged cable anchor in your Demco Stay-in-Play DUO or Air Force One system. Includes set screw to secure the cable in place and restore your systems function.
Replaces a worn or missing ramp bushing on your Demco Kar Kaddy SS tow dolly. This bushing ensures proper spacing, allowing the ramp to tilt up for storage and secure in lowered position for loading.