New Arrivals

Got a rear-vehicle setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 21"4" apart. Made for the Redarc BCDC Alpha 25A.

• Accessories and Parts
• Battery Charger
• Battery Charger Install Kit
• Redarc

Beach, campsite, or worksite - take your adventures off-grid! This all-in-one kit makes connecting your PowerDock a cinch. Hook up solar panels, power up anywhere, and rely on rugged Aussie durability to tackle the wild.

• Accessories and Parts
• Portable Chargers
• Cables and Cords
• Redarc

Got batteries close together? This kit has pre-crimped cables, fuses, and connectors for batteries less than 5' apart. Made for the Redarc BCDC Alpha 50A.

• Accessories and Parts
• Battery Charger
• Battery Charger Install Kit
• Redarc

Power your adventures with the GoBlock Inverter Connector Cable! Effortless, plug-and-play connection to your 400W Redarc inverter keeps you charged up, off-grid, and ready for the wild. Built tough, so you can explore worry-free!

• Accessories and Parts
• Portable Chargers
• Cables and Cords
• Redarc

Wire loom and sensors allow you to monitor levels in your fresh-water tank with your RedVision Total Vehicle Management System. Reads tank state in 20% increments.

• Accessories and Parts
• Smart RV
• Sensors
• Redarc

Expand your TVMS Rogue smart RV system with sensors for monitoring your holding tanks. Safe to use in with fresh water, waste water, or fuel tanks.

• Accessories and Parts
• Smart RV
• Sensors
• Redarc

Mounting panel creates a factory look for your Nissan or Mercedes dash when you install the control knob from your Tow-Pro Elite brake controller.

• Accessories and Parts
• Trailer Brake Controller
• Control Knob Mounting Panel
• Vehicle Specific
• Redarc

Add this bracket to your 2008 or newer Toyota Landcruiser 200 to ensure your Redarc BCDC has plenty of airflow to keep it cool so it can keep your batteries charged. Mounts with included installation hardware.

• Accessories and Parts
• Battery Charger
• Mounting Hardware
• Brackets
• Redarc

Replace a lost or damaged endcap on your Romik ROF/ROB/RPD running board or ROF/ROB/RPD hitch step. Replaces the front endcap on driver's-side board or rear endcap on passenger's-side running board, or driver's-side edge of hitch step.

• Accessories and Parts
• Nerf Bars - Running Boards
• End Caps
• Romik

Replace a lost or damaged endcap on your Romik RB2 V2 running board manufactured 2021 or later. Replaces the front endcap on passenger's-side board or rear endcap on driver's-side board.

• Accessories and Parts
• Nerf Bars - Running Boards
• End Caps
• Romik

Maintain the clean look of your running boards with trimmable rubber mounting bracket covers. Made for use with Romik's drop brackets, these covers conceal your brackets and match your running boards. Trim to fit with scissors. Includes 4 covers.

• Accessories and Parts
• Hitch Step
• Nerf Bars - Running Boards
• Bracket Covers
• Romik

Replace a lost or damaged endcap on your Romik ROF/ROB/RPD running board or ROF/ROB/RPD hitch step. Replaces the front endcap on passenger's-side or rear endcap on driver's-side running board, or passenger's-side edge of hitch step.

• Accessories and Parts
• Nerf Bars - Running Boards
• End Caps
• Romik

Replace a lost or damaged endcap on your Romik RZR running board or RZR hitch step in stainless steel. Replaces the front endcap on driver's-side board or rear endcap on passenger's-side running board, or driver's-side edge of hitch step.

• Accessories and Parts
• Hitch Step
• Nerf Bars - Running Boards
• End Caps
• Romik

Maintain the clean look of your running boards with trimmable rubber mounting bracket covers. Made for use with Romik's drop brackets, these covers conceal your brackets and match your running boards. Trim to fit with scissors. Includes 6 covers.

• Accessories and Parts
• Nerf Bars - Running Boards
• Hitch Step
• Bracket Covers
• Romik

Replace a lost or damaged endcap on your Romik RB2 running board manufactured prior to 2021. Replaces the front endcap on driver's-side board or rear endcap on passenger's-side board.

• Accessories and Parts
• Nerf Bars - Running Boards
• End Caps
• Romik

Replace a lost or damaged endcap on your Romik RAL running board or RAL hitch step. Replaces the front endcap on driver's-side board or rear endcap on passenger's-side running board, or driver's-side edge of hitch step.

• Accessories and Parts
• Nerf Bars - Running Boards
• Hitch Step
• End Caps
• Romik

Replaces one round spring bar for your 800 lb Reese Pro round bar weight distribution system (49912). Can also be used (in pairs) to raise or lower the weight capacity of Reese Pro weight distribution systems to work with heavier or lighter trailers.

• Accessories and Parts
• Weight Distribution Hitch
• Spring Bars
• 800 lbs TW
• Round Bar
• Reese

Replace worn or missing ball mount hardware on your Reese Pro Round Bar weight distribution hitch. This kit restores proper spacing and secure fit to the head assembly, helping maintain sway control and safe towing performance.

• Accessories and Parts
• Weight Distribution Hitch
• Hardware
• Reese

5th Wheel rail adapter plates let you mount your Reese Elite Series under-bed rails (30183 - sold separately) so you can attach your Reese Elite Series 5th wheel hitch. Hardware not included.

• Accessories and Parts
• 5th Wheel Hitch Rails
• Adapters
• Rail Adapter
• Custom
• Reese

Take your rukRak cargo basket on the move by installing this handy wagon accessory. Simply detach your basket from the carrier frame and use the convenient grab handle to get your gear rolling. Pneumatic balloon wheels cover any terrain.

• Modular Hitch Rack
• Accessories and Parts
• rucRack Cargo Carrier
• Accessory Only
• Wagon Add-On
• rucRak

When your headlight lenses start to get hazy, don't be lazy. The sooner you notice the UV breakdown the better. Use this UV-blocking clear coat treatment periodically after lens restoration to maintain the UV protection level. Seals and protects.

• Accessories and Parts
• Vehicle Lights
• Restoration Kit
• Sylvania

This spacer kit is designed to adapt your Timbren suspension enhancement system (GMRCK15S) to your lifted vehicle. Includes (2) 1" rubber spacers, (2) 1/2" rubber spacers, and all necessary hardware.

• Accessories and Parts
• Vehicle Suspension
• Spacers
• Lift Spacers
• Timbren

This spacer kit is designed to adapt your Timbren suspension enhancement system (TORTNDR or TORTTNDR) to your lifted vehicle. Includes (2) 1" rubber spacers, (2) 1/2" rubber spacers, and all necessary hardware.

• Accessories and Parts
• Vehicle Suspension
• Spacers
• Lift Spacers
• Timbren

This spacer kit is designed to adapt your Timbren suspension enhancement system (DR2500CA or DR3500CA) to your lifted vehicle. Includes (2) 1" rubber spacers, (2) 1/2" rubber spacers, and all necessary hardware.

• Accessories and Parts
• Vehicle Suspension
• Spacers
• Lift Spacers
• Timbren