This custom battery tray mounts to the floor of your RV or camper to keep your Alpha150 battery securely locked in place during travel. Quick and simple installation with countersunk fasteners.
Got a mid-vehicle battery setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 14'9" apart. Made for the Redarc BCDC Alpha 25A.
Need to get your PowerDock wired up for your next adventure? This kit makes it easy with color-coded cables, tough hardware, and room to customize. It's built for rough trails, so you can get set up and get going in no time!
Side mounts work with corner mounts (RED79VR - sold separately) to attach single or multiple Redarc solar panels to an RV or boat. Attach mount to surface using a silicon adhesive or common fasteners.
Got a rear-vehicle setup? A seamless installation means less time in the garage and more time on the trails. This kit has pre-crimped cables, fuses, and connectors for batteries up to 21"4" apart. Made for the Redarc BCDC Alpha 25A.
Beach, campsite, or worksite - take your adventures off-grid! This all-in-one kit makes connecting your PowerDock a cinch. Hook up solar panels, power up anywhere, and rely on rugged Aussie durability to tackle the wild.
Got batteries close together? This kit has pre-crimped cables, fuses, and connectors for batteries less than 5' apart. Made for the Redarc BCDC Alpha 50A.
Power your adventures with the GoBlock Inverter Connector Cable! Effortless, plug-and-play connection to your 400W Redarc inverter keeps you charged up, off-grid, and ready for the wild. Built tough, so you can explore worry-free!
Wire loom and sensors allow you to monitor levels in your fresh-water tank with your RedVision Total Vehicle Management System. Reads tank state in 20% increments.
Add this bracket to your 2008 or newer Toyota Landcruiser 200 to ensure your Redarc BCDC has plenty of airflow to keep it cool so it can keep your batteries charged. Mounts with included installation hardware.
Replacement bracket for Rack'Em enclosed trailer shelving systems. Securely holds 2x4 or 2x6 boards to create or reinforce storage shelves in your trailer.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.
Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.
This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.