Add this white door assembly when replacing your rectangle style water heater with a new square style water heater. Double latch design fits a 10-gallon water heater.
Reduce your RV air conditioner startup power demand by up to 75 percent and eliminate that loud, clunking compressor noise. Start and run your AC without the fear of tripping a breaker or overloading your generator.
Keyed alike lock set includes anti-rattle hitch lock to secure your 2" hitch-mounted bike rack to your hitch, 10' cable lock to secure your bike to the rack, and extension lock for Benton 4-bike platform rack.
Trying to pack more without cramming your vehicle? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
Lost a fender on the road or cracked it backing into a tight spot? This replacement driver's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Square tube welds onto your trailer. Works with 4" width inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM43KV (sold separately).
Add extra strength where your Demco cable anchor bolts to the firewall. This steel plate reinforces thin firewalls for Air Force One or Stay-IN-Play Duo installs, keeping the anchor secure.
Moving your 5th-wheel hitch to a new truck? This replacement hardware kit lets you reinstall your Demco universal above-bed base rails (DM6701) with all-new bolts, nuts, and washers - giving you a rock-solid fit for safe, confident towing.
Replaces 1 of the hard plastic cap plugs that install in the 2-1/2" square guide tubes on your Demco Autoslide fifth-wheel hitch. 2 Originally included with your hitch.
Replace the lost or damaged cable anchor in your Demco Stay-in-Play DUO or Air Force One system. Includes set screw to secure the cable in place and restore your systems function.
Replaces a worn or missing ramp bushing on your Demco Kar Kaddy SS tow dolly. This bushing ensures proper spacing, allowing the ramp to tilt up for storage and secure in lowered position for loading.
Replaces the pull pin on the breakaway switch that came with your Demco Air Force One (9599007, 9599019, 9599020, or 9599021) or Stay-IN-Play Duo (SM99251 or SM99243) supplemental braking system.
Round tube welds onto your trailer. Works with 4" diameter inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM73KV (sold separately).
Replace a worn or damaged clevis on your first-generation Demco Excali-Bar tow bar (9511006) with this exact-fit part. Built to keep your tow bar securely attached to your base plate, it restores the solid link your flat towing setup relies on.
If you're tired of your trailer brakes locking when you back up, this hand activated reverse lockout stops the surge actuator from applying the brakes. It installs directly on any Demco DA75 actuator with no electrical hookup required.
Need a tough, reliable connection from your caliper to the main brake lines? The non-stick polymer core locks in pressure, while braided stainless steel fends off road debris. No ballooning, no leaks, just reliable stopping power.
Need a tough, reliable connection from your actuator to the main brake lines? The non-stick polymer core locks in pressure, while braided stainless steel fends off road debris. No ballooning, no leaks, just reliable stopping power.
A standard hose isn't long enough to run a brake line from your actuator to your trailer axle. This 20' hose gives you the reach to make that connection without adding couplers or extensions.