Your Fortress bolt-on cap has been holding it together - now it's time to return the favor. This service kit gives your Fortress cap fresh gaskets, oil fill plugs, and hardware it needs to stay leak-free and pressure tight.
This replacement inner member slide fits into the existing outer member housing of your Dexter or Tie Down surge brake actuator. Fits actuator models LP80, LP85, and LP8500.
Replace worn or leaking copper washers on your Dexter disc brake caliper. These 7/16" crush washers provide a tight, reliable seal between the banjo fittings and calipers to help prevent brake fluid leaks in your hydraulic braking system.
Replace your Coleman Mach, Dometic, or Advent Air RV AC unit with a Furrion Chill AC (sold separately) using this adapter wiring kit. This kit should only be used for AC units from 2025 and newer that have the R32 refrigerant.
Replaces the stainless steel top panel and glass cover for your Furrion 2-in-1 range oven (FGR21G3A2-BG). Includes flat exhaust vent, tray module, and side trim kit.
Replaces the electric control air distribution box for your Furrion Chill HE AC setup (sold separately). 2 Slotted registers provide maximum airflow inside of your RV or camper.
Imagine being on a road trip and not worrying about the gear on your cargo carrier getting swiped when you make a pit stop. The etrailer cargo carrier cage can make that dream a reality, letting you focus on your trip and worry less about your stuff.
Replaces the installation mounting hardware for your Longview original custom towing mirrors (LVT-3100B). Includes 2 clips, 2 knobs, and felt pads - enough for 1 pair of mirrors.
Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.
This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.
Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.
Use this Grade 5 flange nut with Grade 5 bolts (sold separately) to mount your Lippert components on your RV. Secures your steel or aluminum, manual pull-out Tread Lite steps or Ground Control 3.0 front jacks. Zinc plated to resist corrosion.
This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.
Need an air distribution box for your ducted Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.
Replaces your awning roller and fabric. Fits Solera 18' hybrid and power awnings with 8' extension. Installs more easily than replacing just the fabric. Integrated light track gives you the option to add an LED light kit to your awning.