You're replacing your RV's AC and need a non-ducted ceiling assembly with built-in controls. This unit adds front and rear airflow dampers, pop-out filters, and heat strip prep. Designed for Coleman-Mach systems. Other parts required.
Reduce your Coleman-Mach RV air conditioner's start-up power demand by up to 75% and ease the strain on your AC compressor. Start and run your AC smoothly without tripping breakers or overloading your generator.
You're replacing your RV's AC and need a ceiling assembly that puts you in control. This non-ducted air distribution box has built-in knobs, adjustable louvers, and a pop-out filter. Designed for Coleman-Mach systems. Other parts required.
You're replacing your RV's thermostat and need a digital controller that works with your Coleman-Mach single-zone system. This is the thermostat only, but you can pair it with a compatible rooftop AC and ceiling assembly to finish your setup.
Replace the worn or non-working switch panel on your Cummins Onan generator. This panel lets you start and stop your gas or LP generator from a central location and works with select HGJBB, KY, and HGJAx models.
Restore the performance of your Fortress oil cap with this complete service kit. Includes rubber plugs, oil fill plugs, and O-ring seals to prevent leaks, maintain pressure, and keep your hub looking squeaky clean.
This replacement inner member slide easily fits into the existing housing of your Dexter A-84 Series or Legacy UFP surge brake actuator. For use with triple-axle trailers with hydraulic disc brakes.
This brake assembly is engineered for trailers with 9,000 to 10,000 lbs. axles. Its self-adjusting to ensure optimal braking efficiency with minimal maintenance. The integrated parking brake lever adds convenience and safety.
We curated this kit so you can recover a stuck vehicle from almost any distance. There is less risk of injury or gear damage since the ropes and shackles are made from a tough synthetic material that's stronger than steel and safer to use.
Replace a missing or damaged lift knob on your MaxxFan Plus roof vent so you can still open or close the dome when power is out. 3-wing design gives you a solid grip and installs in seconds to keep fresh air flowing.
Replace your damaged MegaSport trailer fender with this direct-fit galvanized steel upgrade. Fits MPG535, MPG550 & MPG595. Rust-resistant, road-tough, and ready to protect your gear from grit, debris, and highway spray.
Mount this rugged rack on your Malone trailer to haul a heavy e-bike up to 200 lbs. Extra-long tray, built-in ramp, and padded locking arm make loading and transport easyeven with fat tires and wide axle spacing.
J-style racks can tap out with wide yaks. This kit adds full-length, padded support to your truck or trailer - no pressure points, no hull dents, no wobble. Perfect for fishing kayaks or any setup that needs more than a strap and a prayer.
Swap out bent or corroded fender brackets on your Malone MegaSport trailer with this factory-style replacement. Built tough to handle road abuse and keep your galvanized fender secure on MPG535, MPG550, and MPG595 models.
Don't let a flat tire delay your adventure. This full-size spare is made for Malone's off-road trailers and includes a lockable mount that secures directly to the frame, so it stays put when the road gets rough.
Why choose between bed rails and a tonneau cover. This adapter lets you mount a CrossBed rack system without ditching your current, or future, set up. No drilling required. Giving you a clean solution that works with what you've got.
A damaged harness can make your RV's leveling system unreliable. This 4-pin interface harness restores electrical connections, ensuring smooth jack operation. Designed for Lippert Level-Up systems, it's a easy fix to get you back to camping.
Lost or bent your extension rods? This replacement set gets your white Solera slide-out awning working like new again so you can get back to smooth RV living.
This is the most convenient way to add LEDs to your RV awning: the light is pre-installed in a plastic strip and mounts to the wall. It's designed to get max brightness with minimal power, reflecting off the RV wall to fill the patio with light.