New Arrivals

This hitch head assembly gives you 4" of extended shank to give you extra clearance for your tailgate, spare tire, and trailer accessories for easier hookup. Replaces the hitch head for your B&W Continuum weight distribution system.

• Accessories and Parts
• Weight Distribution Hitch
• Head
• Trunnion Bar
• B and W

Replace a lost or damaged bracket or install one in a second vehicle to easily transfer your Curt NEXT brake controller. The low-profile design installs above or below the dash and includes multiple mounting options for a secure, unobtrusive fit.

• Accessories and Parts
• Trailer Brake Controller
• Mounting Hardware
• Brackets
• CURT

Heavy-duty replacement support brackets fit Curt TruTrack 2P weight distribution systems with integrated active sway control. Allows you to mount your spring bars on trailer frames up to 8".

• Accessories and Parts
• Weight Distribution Hitch
• Frame Bracket
• Brackets
• CURT

For heavy-duty applications that require cable, this steel winch cable has a break strength of 5,600 lbs and a working load limit of 1,865 lbs.

• Accessories and Parts
• Electric Winch
• Trailer Winch
• Cables and Straps
• 7/32 Inch Diameter
• 5600 lbs
• Wire Rope
• CURT

Replace the leveling sensor wiring harness in your Lippert Hall Effect RV levelling system with this replacement right rear sensor harness.

• Accessories and Parts
• Camper Jacks
• Remote Receiver
• Lippert

Replaces the 3/8" x 2-1/8" pin for your Lippert Solera RV awning. Dacromet finish provides corrosion resistance.

• Accessories and Parts
• RV Awnings
• Hardware
• Pins
• Lippert

Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.

• Accessories and Parts
• RV Awnings
• Fabric
• 8 Feet Wide
• Extends 7 Feet
• Black Fade
• Lippert

Replaces the OneControl Advantage controller with Bluetooth for your Lippert Level Up RV leveling system. Fits all Lippert Level Up leveling systems. Includes flat mounting brackets and hardware.

• Accessories and Parts
• Camper Jacks
• Controllers
• Control Module
• Lippert

Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.

• Accessories and Parts
• RV Awnings
• Arms
• 69 Inch Long
• Pitch Arms
• Flat Awnings
• Black
• Lippert

Replaces the auto-leveling control box for your Lippert Power Gear hydraulic RV leveling system.

• Accessories and Parts
• Trailer Jack
• Control Panel
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Advantage 4-point Ground Control LCD electronics kit.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Controllers
• Control Panel
• Lippert

Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.

• Accessories and Parts
• RV Steps
• Motors
• Control Module
• Steps
• Lippert

This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.

• Accessories and Parts
• RV Awnings
• Arms
• Pitch Arms
• Lippert

Replaces the cartridge valve for your Lippert Flow Max kitchen or bathroom faucet.

• Accessories and Parts
• RV Faucets
• Cartridge
• Lippert

Replaces the drive arm assembly for your Lippert Edge RV awning without LEDs. Includes both the drive head and the arm. Black color matches your existing awning.

• Accessories and Parts
• RV Awnings
• Arms
• Drive Arms
• Lippert

Replaces the mount for your Solera 3000 Series RV awning.

• Accessories and Parts
• RV Awnings
• Mounting Hardware
• Lippert

Replaces 1 3/8" x 1-11/32" pin needed for your Solera RV awning. Dacromet finish resists corrosion.

• Accessories and Parts
• RV Awnings
• Hardware
• Arms
• Pins
• Lippert

This handy 1/2" manifold plug works with your JR Products LP Gas Manifold to prevent leakage and keeps contaminates out for clean use.

• Accessories and Parts
• Propane Fittings
• Plugs
• Manifold
• JR Products

This all-purpose handle is commonly used next to your RV door to make it easier to get in and out, but it can easily be mounted anywhere you need to get a grip. Made with hard plastic for impact resistance and durability.

• Accessories and Parts
• RV Steps
• Grab Handles and Handrails
• Fixed Handle
• White
• JR Products

This all-purpose handle is commonly used next to your RV door to make it easier to get in and out, but it can easily be mounted anywhere you need to get a grip. Made with hard plastic for impact resistance and durability.

• Accessories and Parts
• RV Steps
• Grab Handles and Handrails
• Fixed Handle
• Black
• JR Products

Replacement plug fits on any female quick-disconnect port to keep out debris and moisture. Keeping that port clean is critical to create safe, secure connections and make sure the port works great for a long time.

• Accessories and Parts
• Propane Fittings
• Plugs
• JR Products

This screwdriver-like tool is required to disconnect hoses from your JR Products LP Gas Manifold.

• Accessories and Parts
• Propane Fittings
• Tools
• Manifold
• JR Products

Add extra sturdiness to a fold-out tray, slide-out camp kitchen, or portable table. Once installed, this table leg will fold flat against whatever you mount it to. Leg height adjusts in 1" increments from 22-1/2" up to 35-1/2"

• Accessories and Parts
• Camping Table
• Table Legs
• JR Products