EVs put more stress on tires. Counteract EV Lube locks them in. This synthetic, non-petroleum formula adds extreme adhesion to reduce slippage and protect beads and rims. A secure fit means better performance, longer tire life, and peace of mind.
Tired of cranking, bouncing, or backing in too deep at the ramp? Slydz-On helps your boat slide off and onto your trailer bunks smoother, without the mess of grease or installing rollers. Just spray it on, let it dry, and let it work.
Replace a damaged or worn spring bar on your Curt TruTrack 2P system with this forged steel bar. Designed for 5,000-lb to 8,000-lb setups only (17599). Restores sway control and load leveling for safer, more stable towing.
Install your Curt electric trailer brake controller quickly and easily with this custom wiring adapter. Simply plug one end of the adapter into your controller and then plug the other end into the built-in port beneath your vehicle's dash.
Your trailer's wired right, but the brakes still won't fire. If your factory controller doesn't recognize your electric-over-hydraulic actuator, this adapter sends the signal it needs so the brakes activate, no rewiring required.
Restore connectivity between your switch panel and RV generator with this 10-foot Cummins Onan adapter harness. Designed for use with remote start/stop control panels on HGJBB, KY, and HGJAx model generators.
You're replacing your RV's thermostat and want something easy and reliable. This single-zone analog unit gives you simple heating and cooling control without digital menus.
You're swapping out your RV's AC and need a distribution box to match. Open the louvers for cool air directed straight into the cabin, or close them to push air through existing ducts. Includes a filter that pops out for a quick rinse.
You're replacing your RV's AC and need a non-ducted ceiling assembly with built-in controls. This unit adds front and rear airflow dampers, pop-out filters, and heat strip prep. Designed for Coleman-Mach systems. Other parts required.
You're replacing your RV's AC and need a ceiling assembly that puts you in control. This non-ducted air distribution box has built-in knobs, adjustable louvers, and a pop-out filter. Designed for Coleman-Mach systems. Other parts required.
You're replacing your RV's thermostat and need a digital controller that works with your Coleman-Mach single-zone system. This is the thermostat only, but you can pair it with a compatible rooftop AC and ceiling assembly to finish your setup.
Replace the worn or non-working switch panel on your Cummins Onan generator. This panel lets you start and stop your gas or LP generator from a central location and works with select HGJBB, KY, and HGJAx models.
Replaces the pull pin on the breakaway switch that came with your Demco Air Force One (9599007, 9599019, 9599020, or 9599021) or Stay-IN-Play Duo (SM99251 or SM99243) supplemental braking system.
Round tube welds onto your trailer. Works with 4" diameter inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM73KV (sold separately).
Replace a worn or damaged clevis on your first-generation Demco Excali-Bar tow bar (9511006) with this exact-fit part. Built to keep your tow bar securely attached to your base plate, it restores the solid link your flat towing setup relies on.
If you're tired of your trailer brakes locking when you back up, this hand activated reverse lockout stops the surge actuator from applying the brakes. It installs directly on any Demco DA75 actuator with no electrical hookup required.
Replaces the slow-close seat on your Dometic 310 or 311 RV toilet. Wood construction holds up to regular use and feels sturdy under you. White finish matches your existing toilet, so your bathroom still looks clean and coordinated.
Replace the built-in control panel in your new multi-zone Dometic RV air conditioner with a heat pump to allow your AC which requires a 10-button thermostat to work with your existing 5-button thermostat.