It's never been easier to protect your gear from the elements when you're not flat towing. Just slip this heavy-duty cover over your tow bar and snug it down with the adjustable straps. Easily fits your safety cables and power cord too!
Trying to pack more without cramming your camper? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
This 48" cable can be used to connect a solar charge controller to an RV's SAE port. The wire ends can also be used with a new connector part to create a simple adapter cable.
Your trailer's wired right, but the brakes still won't fire. If your factory controller doesn't recognize your electric-over-hydraulic actuator, this adapter sends the signal it needs so the brakes activate, no rewiring required.
Restore connectivity between your switch panel and RV generator with this 10-foot Cummins Onan adapter harness. Designed for use with remote start/stop control panels on HGJBB, KY, and HGJAx model generators.
You're swapping out your RV's AC and need a distribution box to match. Open the louvers for cool air directed straight into the cabin, or close them to push air through existing ducts. Includes a filter that pops out for a quick rinse.
You're replacing your RV's AC and need a non-ducted ceiling assembly with built-in controls. This unit adds front and rear airflow dampers, pop-out filters, and heat strip prep. Designed for Coleman-Mach systems. Other parts required.
You're replacing your RV's AC and need a ceiling assembly that puts you in control. This non-ducted air distribution box has built-in knobs, adjustable louvers, and a pop-out filter. Designed for Coleman-Mach systems. Other parts required.
You're replacing your RV's thermostat and need a digital controller that works with your Coleman-Mach single-zone system. This is the thermostat only, but you can pair it with a compatible rooftop AC and ceiling assembly to finish your setup.
Replace the worn or non-working switch panel on your Cummins Onan generator. This panel lets you start and stop your gas or LP generator from a central location and works with select HGJBB, KY, and HGJAx models.
Restore your Dutton-Lainson StrongArm DC electric winch's functionality with this Switch Pocket Replacement Kit. Includes all necessary hardware for a complete and secure repair.
This fitting replaces the 1/4" pushlock to male 1/8" NPTM fitting for your Demco Air Force One supplemental braking system. Straight design allows for streamlined routing of your air line.
Restore safe towing with this 2" ball coupler for your Demco DA70 actuator. Replaces worn or damaged coupler and bolts directly to the actuator housing.
Bolt this locking plate onto your Lippert Helux pin box to prevent the king pin from rotating inside your Demco Autoslide fifth-wheel trailer hitch. Hardware included.