Restore safe towing with this 2" ball coupler for your Demco DA70 actuator. Replaces worn or damaged coupler and bolts directly to the actuator housing.
Bolt this locking plate onto your Lippert Helux pin box to prevent the king pin from rotating inside your Demco Autoslide fifth-wheel trailer hitch. Hardware included.
Replaces the fuse holder for your Demco Stay-IN-Play Duo (SM99251 or SM99243) or Air Force One (9599007, 9599019, 9599020, or 9599021) supplemental braking system.
Replaces the 2-5/16" coupler for your Demco Recon Gooseneck to 5th wheel hitch adapter base (DM6021). Provides the attachment point for the gooseneck ball in your truck bed.
Lost a fender on the road or cracked it backing into a tight spot? This replacement passenger's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Lost a fender on the road or cracked it backing into a tight spot? This replacement driver's-side fender assembly gets your Demco KarKaddy SS or KarKaddy 3 tow dolly looking sharp and road-ready again.
Square tube welds onto your trailer. Works with 4" width inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM43KV (sold separately).
Replace the lost or damaged cable anchor in your Demco Stay-in-Play DUO or Air Force One system. Includes set screw to secure the cable in place and restore your systems function.
Replaces a worn or missing ramp bushing on your Demco Kar Kaddy SS tow dolly. This bushing ensures proper spacing, allowing the ramp to tilt up for storage and secure in lowered position for loading.
Round tube welds onto your trailer. Works with 4" diameter inner tubes (sold separately). Pairs perfectly with the eZ-Latch gooseneck coupler DM73KV (sold separately).
It's never been easier to protect your gear from the elements when you're not flat towing. Just slip this heavy-duty cover over your tow bar and snug it down with the adjustable straps. Easily fits your safety cables and power cord too!
Trying to pack more without cramming your camper? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
This 48" cable can be used to connect a solar charge controller to an RV's SAE port. The wire ends can also be used with a new connector part to create a simple adapter cable.
Trying to pack more without cramming your vehicle? If you've already got a bumper-mounted cargo carrier, this kit turns it into a lockable, front-loading cargo cage so extra bags or muddy gear can ride outside, covered and out of sight.
This breakaway switch sounds an alarm when the pin is pulled, so you know it's working. Wire it into your trailer's brake system so if your trailer becomes uncoupled it will activate the trailer brakes, giving you time to move to safety.
Keep your trailer plug off the ground and out of the dirt with this holder. Secures to your trailer and gives you a spot to clip your breakaway cable when it's not in use. Fits 7-way plug.
If you're tired of your trailer brakes locking when you back up, this hand activated reverse lockout stops the surge actuator from applying the brakes. It installs directly on any Demco DA75 actuator with no electrical hookup required.
Designed to work with your etrailer scissor jacks, this unique socket is used with your power drill to extend and retract your jack up to 10 times faster than with a manual crank. Works with 3/8" drill bits.