You're installing a brake controller in your Chevy or GMC truck and want a no-fuss setup. This plug-in adapter connects directly to the factory tow package port under the dash. No cutting or splicing. Just plug it in and you're ready to tow.
Your trailer plug's hanging by a zip tie and a strip of duct tape, barely holding on. You hit a bump, lose the connection, and now you've got no lights. This bracket fixes that. Mount it once, snap the plug in, and it stays put.
You're wiring up a breakaway system and need a switch you can trust. This one's simple. Mount it to the frame, connect the leads, and hook up the pin. If the trailer disconnects, it pulls free and completes the circuit to trigger the brakes.
Add this LED third brake light to your Outlander soft truck topper to make your truck more visible to vehicles behind you. Connects to a 12-volt power source and mounts on the rear bow of your truck topper. Water-resistant seal prevents damage.
Your old left brake is worn out and pulling uneven. You bolt on the new assembly, connect the wires, and it adjusts itself with every stop. Braking's balanced again and the trailer's back to doing what it should.
Your trailer's braking feels off and the right side's worn. You bolt up the new assembly, wire it in, and you're done. It adjusts automatically and brings the trailer to a smooth, steady stop every time.
Custom base rails are specifically designed to fit your vehicle. Required to mount your TruXedo Elevate Rack System, these rails work with both telescoping and fixed racks (sold separately). T-slot channels accept a variety of accessories.
Your old left brake is worn out and pulling uneven. You bolt on the new assembly, connect the wires, and it adjusts itself with every stop. Braking's balanced again and the trailer's back to doing what it should.
This large jack pad effectively distributes weight on wet or unstable ground. Also keeps your driveway in good shape when parked at home. Works with round or square-foot stabilizers, tongue jacks, or even awning supports.
Stackers lock together like building blocks, making them a versatile tool when setting up your camp. Use as pads for jacks and stabilizers or build a ramp shape to level your RV. Includes 10 rectangular Stackers.
Stackers lock together like building blocks, making them a versatile tool when setting up your camp. Use as pads for jacks and stabilizers or build a ramp shape to level your RV. Includes 10 rectangular Stackers and storage bag.
Stackers lock together like building blocks, making them a versatile tool when setting up your camp. Use as pads for jacks and stabilizers or build a ramp shape to level your RV. Includes 10 square Stackers.
Restore smooth waste valve operation with this 48" cable. It lets you open and close your valve from a safe, easy-to-reach spot without crawling around. Built to handle tough conditions with a rust-resistant stainless steel inner wire.
These are small and easy to carry while being sized just right for round or square-foot stabilizers, tongue jacks, or even awning supports. Creates a stable, level surface on gravel or grass.
Stackers lock together like building blocks, making them a versatile tool when setting up your camp. Use as pads for jacks and stabilizers or build a ramp shape to level your RV. Includes 10 square Stackers and storage bag.
Replaces a broken screen frame and screen on your Ventline Ventadome RV powered lift roof vent for motor homes and enclosed trailers. Held securely in place by the frame, the screen keeps out debris and insects when the vent is open.
Replace your lost or damaged Voyager WiSight 2.0 monitor cord. This direct replacement 12-V DC accessory cable plugs into any cigarette-lighter outlet and plugs into the 4.3" WiSight 2.0 monitor to restore power in seconds.