Most Popular Ultra-Fab Products for Jeep TJ
change vehicle# 1
Ultra-Fab Stackable Stabilizers for Small Trailers and Campers - 6,000 lbs - Qty 4
- view all Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Aluminum
- 5001 - 6000 lbs
- 17 Inch Lift
- Not Mounted
- 4 Jacks
- Ultra-Fab Products
More Information >
by: Robert E06/07/2019
These Jack's made both building and positioning my teardrop onto the trailer bed easier. At campsites they easily level the trailer. So yes I'm happy.
View More
View Less
by: Pauline11/06/2020
we are using these stabilizers for supporting our offloaded truck camper (adventurer 910db) where we reside full-time ... they are very easy to use, provide excellent support for the truck camper and have eliminated 98% of wobble ... the support structure includes jack pads, e-trailer stabilizer, 2x6 pressure treated lumber, 4x8 3/4 inch pressure treated plywood
View More
View Less
# 2
Ultra-Fab Stackable Stabilizers for Small Trailers and Campers - 6,000 lbs - Qty 2
- view all Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Aluminum
- 5001 - 6000 lbs
- 17 Inch Lift
- Not Mounted
- 2 Jacks
- Ultra-Fab Products
More Information >
by: Kent 07/12/2022
Perfect for the four corner supports of our Jayco 175 RD. Much easier to deal with than the scissor jacks installed on the camper. E trailer got them to us quickly as usual!
View More
View Less
by: Rick K.04/12/2019
Our camper came with stabilizers only in the back. Once we level it we put these under the front corners and it gets rid of any movement in the camper like you get when front is only on tongue jack.
View More
View Less
# 3
Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- view all Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Ultra-Fab Products
More Information >
by: Chuck08/20/2017
Finally got around to installing my PT II Stabilizers 30" front and rear of our 26' Surveyor. Pre - assembled them to make sure they went together ok. Luckily I had two sources for power front & rear which made wiring easy, I used a Buss block to make all positive connections, grounds straight to frame, soldered all connections and heat srinked to seal. Using the 3/8" self tappers was fun.Well got it all together and all works well makes trailer very stable, don't have to worry about scissor jacks collapsing anymore.
View More
View Less
by: Bobby S09/06/2016
I finished the assembly and install of the power twin II stabilizer and have included pictures of the install. This is a good quality unit and I am very happy with how it works. Bob
View More
View Less
What our customers are saying:
"I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future."