# 1
Curt E16 5th Wheel Trailer Hitch w/ Slider for Ford Towing Prep Package - Slide Bar Jaw - 16,000 lbs
Bolt coming out on roller wheel, rusts very quick, and locking arms don’t pull that well or easy from outside of the bed
Ford F-350 Super DutyDoesn't operate as easily as I hoped. Sticks when trying to slide which means jumping in and out of cab many times. Also its heavy as it should be,but it doesn't come apart easily for removal in two pieces that can be lifted separately. You need a winch to remove it safely. Its a pain in the you know what. I like my old two piece hitch better. I could take it in and out in a few minutes, but it won't work in my new f350.
# 2
Curt E16 5th Wheel Trailer Hitch w/ R16 Roller - Slide Bar Jaw - 16,000 lbs
Etrailer sent me a one year follow-up email. Since purchasing this I've used it to tow our 11k lb camper about 5k miles. The hitch and slider have worked exactly as they should and I have no complaints.
Well, I haven't towed with it yet but we'll see how that goes. I purchased this hitch because I needed to drop the height as much as 6 inches. My previous hitch was dropped to the lowest setting and still 17 inches high! This E16 goes down to 14 inches... Assembly was straight forward and all pieces were present ( even 4 big washers which were not illustrated anywhere in the instructions as to where they went) The hitch seems well built but the welder needs to be more thorough in cleaning his Slag (got my finger good when I picked up the top plate) Stickers were falling off everywhere (my heat gun fixed those) But a couple notable design flaws... The top cradle for the 5th wheel plate is a triangular shaped arch and the top plate has an axle which is perfectly round. So when the 5th wheel assembly is down in the cradle, there are only two little points of contact instead of the cradle fitting uniformly around the axle rods...we'll see what kind of wear this causes. Next, the green ring on the indicator rod looked like a 3 year old toddler wiped lipstick on it. (Green paint is supposed to be in the little groove cut in the rod but instead, is smeared all over the end of the rod) Lastly... The side plates have a two rows of holes for height adjustment...I have installed the bolts to position the overall height at the lowest possible setting. However, there are two more holes in the tie plate but the casting prevents the sideplates from dropping down even lower. Definitely confused as to what the extra holes are for and disappointed that I can't drop this even lower... Definitely seems heavy duty, but again, I haven't towed yet, so hopefully the play in the base rails doesn't translate into obnoxious clanking and rattling.... If so, I will definitely be doing another review
What our customers are saying:
"Very easy process, good prices and my products were shipped on time and were delivered on time. The instructional videos online helped make installation easy!"