Most Popular Rhino Rack for 2016 Nissan Murano

Nice ski/snowboard rack for the money, easy to install, Was able to hold 1 snowboard and 4 ski's (kids) I would not consider it 5 stars as its missing a few considerations for something you will be using in the cold (which IMO should be as easy to use as possible): * locks are a bit finicky, in fact one of the two racks refused to lock when any pressure was on the top bar (meaning anytime it has skis or boards in). I actually had to have to the top arm up, insert the key and slightly turn it, then close the arm in order to be able to lock it. * the latch mechanism must be perfectly aligned to close and that is difficult to do in the cold with gloves on if you are not directly in front of each component. So if your car is like mine you have to close one latch (which requires standing on the inside of the vehicle with the door open to reach it), then get down open the rear door and repeat. If the mechanism was designed with some sort of self aligning guide the extra steps would not be necessary as you could reach over and close the second one without moving.

Howzit etrailer.com & staff. the rack itself is sturdy and more aero than comparable units. For my 2017 Subaru Crosstrek (OEM) Aero Bars, it was necessary to shim the (rear) lower/leading edge clamp assembly with two 1/8” x 1.5” x 1.5” (EPDM) rubber pads. The bars are shaped like a wing – and these shims helped to level the rear rack with the one in front. Overall - it looks very clean and functional. I might screw on some rubber ends over the ends of the mounting bolt to complete the project. Time to make some turns. Thank you!!

Click to Enlarge

Click to Enlarge

Nice ski/snowboard rack for the money, easy to install, Was able to hold 1 snowboard and 4 ski's (kids) I would not consider it 5 stars as its missing a few considerations for something you will be using in the cold (which IMO should be as easy to use as possible): * locks are a bit finicky, in fact one of the two racks refused to lock when any pressure was on the top bar (meaning anytime it has skis or boards in). I actually had to have to the top arm up, insert the key and slightly turn it, then close the arm in order to be able to lock it. * the latch mechanism must be perfectly aligned to close and that is difficult to do in the cold with gloves on if you are not directly in front of each component. So if your car is like mine you have to close one latch (which requires standing on the inside of the vehicle with the door open to reach it), then get down open the rear door and repeat. If the mechanism was designed with some sort of self aligning guide the extra steps would not be necessary as you could reach over and close the second one without moving.

E trailer I have a 2019 Mazda6 and purchased the rhino rack series 2500 parts (fit kit #DK289, foot pack #RRRLKVA, aero crossbars#RRVA126B-2), and the rhino rack snowboard/ski carrier #RR576. My car does have fixed mounting points underneath the strip on the roof so I opted to add them to my roof and not use the clamp for kit that goes in the door jam. Every time I entered the year, make, and model of my car, the parts came up with the clamp fit kit part #DK387 which I did not want. But after some research, I found the correct fixed mounting point fit kit. The site of course told me that this part wouldn’t fit my car but after looking at the customer reviews, I saw them used on Mazdas. All of the rhino rack instructions were not the best. We did have to make some adjustments. One of the instruction packs tells you how long you’re supposed to cut the rubber pieces that go into the crossbars based on your car but unfortunately, the measurements were wrong for my car (picture- front 166mm is wrong). The front bar length was about an inch too short and I had to add more rubber to make it longer to fit the fixed mounting points on my roof. After some time of trying to interpret the instructions, and looking up whatever available instructional videos were online, we finally finished installing them and they do look really nice. At higher speeds on the highway I can definitely hear more noise. The actual snowboard carrier is fine, fits all 4 boards fine. It is a little difficult to close once I have my boards in there because you have to push the top bar all the way down and hold it down to be able to turn the key to lock it. I’m just happy I don’t have to shove the boards in my trunk. I do like that all the parts in this series come with locks and keys. So far no problems. Overall good product.

Click to Enlarge

Click to Enlarge