Firestone union T fitting # F3025-1 is the correct one for your air bag kit # F2445 but since your air lines were also potentially damaged you may want to consider Air Line Service Kit # F2012 which includes the T, air lines, elbow fittings and Schrader valves. I suggest this just in case, since that once you're into the repair job you may find other items may have been damaged. It's not a terrible idea to have these parts around as spares.
While you're doing this fix-up job you might... view full answer...
You can use Air Lift Replacement Rear Air Spring # AL60315 for the rear axle kit # AL60820 that is installed in your 2011 Jeep Liberty.
If you do not already have a compressor and you are always manually inflating the springs you might consider adding one like # AL25592. Not only does this compressor make it easy to find your ideal pressure but it can also automatically maintain a pre-set minimum pressure which can help avoid damage to the springs caused by under-inflation. view full answer...
I would recommend the Air Lift Load Controller with Heavy Duty Compressor part # AL25854 for use with the Air Lift LoadLifter 5000 part # AL88233. The heavy duty compressor of this kit will inflate the bags quicker and the controls allow you to maintain air pressure from within your vehicle. view full answer...
Are you looking for just the upper, lower, and axle strap brackets or do you need a complete hardware kit to install Firestone air bags on your '88 K1500? view full answer...
We do have just the replacement air bag for the Lippert Center Point # LC1565391 or # LC1565401 and it is found on our site as part # LC1564251.
There really is no harm in keeping an extra pair of new air bags on hand so that in the event that something happens you can swap them out. It is much better to have it and not need it than to need it and not have it.
You might also be interested in one of our air compressors like part # BDW41004 so that you can easily fill your air bags if you... view full answer...
Between the Air Lift # AL57228 you had on your F-150 and the two similar options for a 2013 GMC Sierra 1500 ( # AL57211 for an 8 foot bed and # AL57204 for a short bed), there are a lot more differences than just the top and bottom plates. The bags, roll plates, fittings, and air lines will all be the same, but that's basically it. With that said, unfortunately, we do not have just these plates currently available.
I highly recommend replacing the entire unit with the one that is designed... view full answer...
Yes, we do have the replacement top mounting brackets for the Firestone Ride-Rite Air Helper Springs - Double Convoluted - Rear Axle item # F2299. You will want the Replacement Bracket for Firestone Ride-Rite Airbags item # F5757 and/or the Replacement Brace Bracket for Firestone Ride-Rite Airbags item # F5758.
If you need the lower bracket we have it too. It is the Replacement Lower Bracket for Ride Rite Airbag item # F5370.
I also recommend the Air Lift WirelessAIR Compressor System... view full answer...
The air compressor part number 16092 tells me you have the Air Lift WirelessAIR Compressor System for Air Helper Springs part AL72000 and the correct replacement remote for this is the Replacement Wireless Remote for Air Lift WirelessAIR Compressor System part # AL73002. I have attached a photo that shows you how to pair the remote to your system once you get it. view full answer...
It sounds like you're looking for the 72704 replacement remote for an Air Lift system, which can be found with the Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs # AL72704. view full answer...
Yes, the pressure sensor # AL24558 is a fit for your Air Lift compressor system. And you are correct, they are sold in quantities of one. view full answer...
I called Firestone to confirm the fit for you, and found that the # F2710 is a fit for the 2019 Ram 3500 pickup. For cab/chassis models, you'll want to go with # F2478.
You might also be interested in an onboard compressor system like # F2219. A compressor system would allow you to add or subtract pressure from the system while you're on the move without having to exit the cab or having to find a gas station that has free compressed air. view full answer...
You are in luck! We carry the replacement air compressor check valve Firestone Air Command compressors.
- Replacement Air Compressor Check Valve # F27VV
This air compressor check valve fits the following Firestone kits: F2047, F2097, F2219, F2590, F2266, F2168, F2591, or F2239 view full answer...
Sounds like you are looking for the control panel for your Firestone Ride-Rite Air Helper Springs, # F2398, which you referenced. We offer several control panels depending on whether you need the electric or pneumatic version and whether you need the single function or dual function panel. The dual path lets you control both sides of your airbags individually.
Take a look at the provided link which lists all of the control panels we offer. view full answer...
The screen going dark on your Air Lift WirelessAir Compressor is something that will need to be fixed by replacing the controller entirely. We have replacement controllers depending on your exact kit (see list below) but since yours was bought within 2 years you should be able to get the controller replaced under warranty by Air Lift or through the place you received the kit from. I confirmed this with my contact at Air Lift.
Remotes for WirelessAir Compressor Kits
Part - # AL73002 is... view full answer...
There is no remote control that comes with the Air Lift LoadLifter 7500 # AL57595, the remote comes with the compressor system. There are two possibilities for replacement remote controls so you will need to know the compressor system you have; if you have the Air Lift WirelessAIR Compressor System # AL74000 then the correct replacement remote is # AL73002.
Should you have the Air Lift WirelessONE Compressor System # AL25870 then the correct replacement remote is # AL72704. view full answer...
Your Firestone Air Spring # F6401 has a dual thread stud. Currently you have a connector with the 3/4"-16 adapter for the air line. We will have the Firestone Connector # F3046-1 or Firestone Elbow Connector # F3031-1 that will screw into the internal 1/4" NPT threads located inside the stud. view full answer...
I reached out to my tech contact at Firestone and there are not any rebuild kits or diaphragm kits for their compressors. The pressure switch you asked from is one of the only replacement parts available and isn't the issue you are describing.
My contact said you will need to replace your compressor. I recommend the Firestone Standard Duty Air Compressor - 130 psi # F9284 which will work with your current switch. view full answer...
The digital gauge included with the Firestone Air Command, part # F2490, that you have is no longer available. I reached out to Firestone to confirm this.
Your best option is to replace the compressor kit with a new one. I recommend upgrading to at least the standard duty compressor using part # F2158. If you want to go with the heavy-duty compressor it's part # F2097. Both kits have an analog gauge. view full answer...
Go To Results