Hi Marcus,
Yes, you can replace the standard pin box on your Keystone Sprinter Campfire 5th Wheel trailer with a Reese Goose Box with Air Ride. That said, we don't have any way of knowing which pin box model is on your trailer, so to find out the right replacement you'll have to take a couple measurements.
I have added a link below to a help article called "4 Steps to Choosing Your 5th Wheel Pin Box" and if you scroll down a bit in the article, it walks you through the measurements... view full answer...
Hey Alonzo, on the bottom edge of the Furrion remote part # FR88NR there is a small indent that you need to put your nail into and pull towards the battery slot to release it so that you can slide the battery slot out.
See attached pic. view full answer...
Hey Ryan, you need to use the 4 point system part # LC358590 when the distance between the front and rear jacks would be less than 20 feet and the 6 point part # LC675817 if that distance would be greater than 20 feet.
The rear jacks on the 4 point system install behind the rear axle on the trailer frame so measure from behind the rear axle to where you current landing gear is and determine from there which kit to use. Since you said 18 foot I would assume the 4 point is what you need. view full answer...
Hi Shane,
We do not offer an exact replacement for the ladder on your Keystone Sprinter, but we do have a universal option that can work, the Stromberg Carlson Exterior RV Ladder # LA-401BA.
This ladder is 99-1/2" tall though it can be trimmed if your ladder is shorter, and will bolt onto the sides and roof of your trailer. I've added a link below to a video review for you to check out as well if you'd like to take a look. view full answer...
The Correct Track used to be made by Lippert but they stopped carrying it and after some time RV Ride Control released the third generation version of it with the part # RR23QX. Like other trailer suspension components like hangers and shackles there isn't a weight capacity listed.
We actually have a kit with upgraded shackles and wet bolts that was specifically designed to work with the Correct Track with the part # MR98ZR. view full answer...
The Landing Gear Set part # RVLG-8HDL can be used as a manual system or a single motor electric system. The reason for this is because you can only use a motor with the lead leg and the above set has one lead leg and one follow leg. Therefore, you'd need to obtain an additional lead leg for a dual motor setup, the Replacement Lead Jack part # LG-179013. view full answer...
I am sure your wheels are rated for the 110 psi that your tire requires but your valve stems may not be rated for the pressure rating as that is typically the weak point so you could use the part # AM20906. view full answer...
If you are referring to the support arm on a set of electric stabilizer jacks then we do offer these, the Replacement Electric Stabilizer Jack Support Arm for Lippert Components RV Jack. The part # LC1134121 for black or part # LC1134121 for yellow.
If this was not what you were looking for please just let me know. view full answer...
The Kenda Karrier # AM10303 would be a good tire for you. The main thing that you want to consider is the weight of your camper. These tires are rated for 2,830 lbs at 80 psi. You may have had this same rating of tire before from factory, but with 4 of these tires you are below the GVWR of 12,370 lbs.
If you are loading your camper to its fullest capacity you may want to go with a tire that is rated for more weight. If they will fit your camper, the Provider ST235/85R16 # A16RGBML would... view full answer...
Go To Results