Yes, the Ventline Pinnacle Ducted RV Range Hood with Light # VE98SR can replace your existing High Pointe range hood. This has the same dimensions at 20" wide x 18" deep x 4-3/4" tall. There will be a small difference in the vent opening since this is 9-5/8" wide vs 10" wide on the High Pointe but that won't be an issue. view full answer...
The division at Atwood that handled the jacks and landing gear was sold off to Lippert so direct replacement parts are not available. But it is likely that the gear box and motor of another brand will still fit. And yes, the gear box and motor do just sort of hang there.
Gear box # RVLG-RDBOX is one possible option. With it you can use motor # M1230. For the driver leg D shaft there were 3 possibilities for Atwood landing gear depending on which model it is (standard duty, heavy duty,... view full answer...
Since you have the Lippert Ground Control 2.0 with the module number 307296 the correct controller is the part # LC242623 that you referenced. view full answer...
Based on the gross vehicle weight of your 2018 Jayco Eagle HT 29.5 BHDS 5th wheel and the current length of 25.75" the 4-Leaf Double-Eye Spring # e28SR is the most likely spring to fit your 5th wheel. This leaf spring is rated for 2,500lbs per leaf spring and has a length of 25-1/4" from center of eye to center of eye when unloaded. As the spring takes on weight it can measure up to 28" when fully flattened so if you can measure from the center of eye to the center pin along the curve of... view full answer...
The closest option we carry to your 17 x 11-1/2" sink is the Better Bath RV Bathroom Sink # LC209354, which is 17" long x 14" wide. If you're able to trim the cutout hole a bit wider then you'll be able to swap of to this sink instead. If not, I would reach out to Lippert directly since they have a much larger selection of sinks and are a top OEM choice so you might also be able to find your exact sink model to replace it with. view full answer...
If you're replacing a 4 wire electric switch with the Replacement Electric Jack Switch with Harness for Lippert High Speed Stabilizer Jacks Item # LC387874 you'll be fine using this replacement. The screw plate on this switch measures 2-1/4" x 3-5/16. view full answer...
Go To Results