Troubleshooting points to your exhaust-brake solenoid? This 24 VDC replacement gives you defined 3-way air control, 1/8"-27 NPT ports, and a 0-to-150-psi operating range to match against your existing pneumatic system.
Once troubleshooting points to the pneumatic control solenoid, replacing it is about restoring the valve that directs air to and from your exhaust-brake actuator. This 3-way, 2-position pneumatic solenoid uses a 24 VDC coil to control that airflow, giving the system a defined electrical and pneumatic switching point. With the correct command applied, supply air can move toward the actuator, and when the command ends, actuator pressure has a path to vent so your exhaust brake can disengage.
A similar-looking valve can still operate the wrong way, especially when your system depends on pressure releasing promptly after the brake command ends. The 1/8"-27 NPT IN port is normally closed and opens when the 24 VDC coil is energized, while the 1/8"-27 NPT CYL port is normally open to exhaust at atmosphere when de-energized. That defined valve behavior lets supply air reach your actuator when commanded and gives trapped actuator pressure an exhaust path when the solenoid switches off.
On an older or poorly documented installation, the most useful comparison comes from the electrical and pneumatic details already on your vehicle rather than appearance alone. This solenoid is rated for 24 VDC with 50 ohms coil resistance, 1/8"-27 NPT pneumatic ports, a 0 to 150 psi operating range, a 0.060" +/- 0.003" orifice, and approximately 18" of 18 AWG wire lead. Matching those details and the required normally closed IN and exhaust-open CYL behavior gives you a concrete way to judge the replacement before disturbing short air lines, fittings, or existing wiring.
A frame-mounted pneumatic valve can see moisture, road spray, temperature swings, and repeated cycling, so construction matters beyond the initial installation. The valve body is anodized aluminum, while the carbon-steel solenoid body is zinc chromate plated for corrosion protection, and the specified operating temperature range runs from -40 F to 185 F.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi, everybody, Andy here with etrailer. Let's take a quick look at this Pacbrake Pneumatic Exhaust Brake Solenoid. Now, this is a 3-way, 2-position pneumatic solenoid valve, which basically means that it controls airflow by switching between two states, either direct, directing air one way, or stopping or redirecting it. This is going to run on 24-volt DC so it's commonly used in industrial or mobile setups where that power standard is already in place. The valve itself is built to hold up in tough conditions. The main body is made from anodized aluminum, which is gonna help resist corrosion while keeping it lightweight.
The solenoid housing is zinc chromate, rather, plated carbon steel, adding extra durability and protection against wear and rust. For connections, this does use 1/8-inch NPT inlet and outlet ports, so it's gonna fit a wide range of standard pneumatic systems. And it also comes with this 18-gauge wire lead. It's about 18 inches long, so that's gonna give you enough length to make installation straightforward without needing immediate extensions. Now, if you happen to have any other questions about this, don't hesitate to reach out.
We wanna make sure that you're getting exactly what you need. Well, again, my name's Andy, thank you for joining me.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.




Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.