Replace missing or worn gas strut mounting points with this ball stud bracket set for compatible gas struts. The 10 mm ball fitting gives the strut a direct attachment point, and the 2 included brackets cover both ends of the setup.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steven here with etrailer. Today we're taking a look at these ball stud brackets for the RV Designer gas struts. So folks, very simple part we're looking at today. You're gonna get quantity two. These are 10 millimeter balls, and these just simply thread into the point where they thread into wherever they match up, which you're replacing, and use a wrench to tighten 'em down.
And this allows direct attachment for those compatible gas struts on your gas strut on your door that opens and closes. Then it will just pop down literally on top of this. It usually has a clip on top of it for pulling off the old one, but these are just the replacement studs with the 10 millimeter ball fitting on there. Again, quantity two, they're heavy duty steel. I'm Steven.
Thanks for watching.
Ratings & Reviews
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.