Most Popular Tinted for Freightliner Sprinter

Product was excellent and the installation videos on the website were invaluable!

Bought this to replace original bath fan (Maxxair) when the raising mechanism broke. I ordered it from etrailer on a Wednesday, and it was delivered on Friday....super fast delivery. Easy install, and I think we will really like it's features (i.e. 10 speed reversible fan, rain proof cover).

Fan arrived quickly and was an exact replacement for our Hail storm damaged unit. Thanks eTrailer!

Our hunt club has 2 pit blinds that are used for waterfowl hunting. Each blind is essentially a concrete box with walls, floor and top 4 inches thick and dimensions of 12'x5'x5'. Each blind is buried to a depth of 5 foot to where the top is flush with ground level. Access is through the top using 24 inch wide manhole lids that are made of high density plastic. The cooler air inside of the blinds clashing with warmer air absorbed by the concrete and manhole lids at ground level caused condensation that made the inside damp and smelly. We only hunt 3 months each year, so needed a vent solution for the other 9 months the blinds were not in use. We also needed something that could be powered by DC voltage from a solar panel due to the remote location. In July 2015 we installed each fan into a manhole cover and used water-tight conduit and electrical boxes to run the wiring from the solar panel to each fan. Great solution! Once enough daylight hits the solar panel the fan blades start moving and run constantly until sundown. Will see how long these things last but so far so good

Delivered as promised in fine shape. MaxxFan fit perfectly in existing 14X14 opening. Simple install and is functioning as designed.

This fan was great. I had an issue initially with the motherboard and the company replaced it ASAP at no charge. Really good customer service and an excellent fan!.

Product description, fitment, construction materials, size, all matched the website. Very good product for replacing your vent on a trailer. Excellent support and shipping from company.

Installed this vent into my Haulmark Transport 6'x12' enclosed trailer. Installation was easy, I cut a 14.25" x 14.25" inch hole between two crossmembers in the roof and dropped it in place. Because the roof on this enclosed trailer is so thin, I used a piece of 3/8" plywood so sandwich between the interior garnish and actual vent. I cut the same size hole into the plywood and left a 2" lip all around. I use 28 #8 x 5/8" stainless screws to hold it in place, pre-drilled with 1/8" bit. I then used roofing tar to seal the vent and put masking tape all around, leave 1" from the flange to ensure good coverage. I then removed the masking tape, leaving nice clean lines. Interior garnish is held in place by #8 x 3/8" galvanized screws. Huge kudos to etrailer for carrying such awesome products for great low prices and offering super cheap shipping to Canada!