Most Popular Stop/Turn/Tail for Coachmen Freelander Motorhome

Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.

Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.

Bought these LED Stop/Tail lights for my new dump trailer. The factory stop/tails are mounted very low, and any car directly behind me blocks my lights from the 2nd or 3rd car behind me. So I mounted these new ones up as high as I could to let people know I am stopping or turning. I also mounted a side marker light so I could see where the trailer was while backing up at night. The factory marker lights are so low I can’t see them in my mirrors because they are blocked by the step on the drivers side and the spare tire on the passenger side. I am a retired 18 wheeler driver of 47 years.

I am in the process of renovating a 1966 Airstream. I wanted to upgrade the tail lights and the clearance lights. I found etrailer.com on a web search. I ordered the round 4" LED, rubber 4" grommet, and Oval LED clearance light. The round stop with grommet adapeted perfectly into the lens on the Airstream. I will feel so much safer now with the added visability. The lights are stellar.

It was an exact replacement and workded fine.

Thus far a good light, I am using it as a rear foglight on my truck. It's been surviving the Florida rains, time will tell how it holds up to the elements, I'll write a follow up during our foggy season here. It's a bright light, not too large. My use may be unorthodox, but in the couple of weeks since I installed it still tests good.