Most Popular Edge for 2019 Ford F-150

Works pretty good. I get a mile to the gallon better. When I tow a 13000 lbs fifth wheel camper it really does a great job. More hp and 1.6 mile to gallon better. Now the truck doesn’t shift gears as much.

Not a huge difference, towing my 28' travel trailer, but I do appreciate the firmer shifts and ability to see more engine parameters on screen. Over all, happy with the product. Easy to install and use.

Very buggy the unit would have constant crashes just with going through the menus. NEVER TRUSTED IT to actually make a change to my truck.

It works

The service of e-trailer has been great, and once programmed the device seems to be good (I am yet to put many miles on the truck to see if it does as advertised). The problem with the device is the upgrade software. It took me more than 8 hours to finally get the device upgraded. The design of the software leaves a lot to be desired and the device kept timing out during the upgrade process that rendered the device useless and required a complete restart of the upgrade process. If you buy the device and decide to upgrade it as suggested then you need to have high speed internet, turn off all virus and firewall protection, and be patient because the software does not respond quickly and sucks up all of the computer resources so don't do anything else during the upgrade process. This is no fault with etrailer who were better than responsive in getting the order out and delivered.

If I would have known that when I wanted performance and or heavy towing I was going to have to use 91 octane, I might not have purchased the product..... I can't decide if its worth the extra cost of 91 octane gas.....

The Edge CS2 won't pull the PID list for my van, so I just get to see the standard PIDs/guages and cannot update to additional PIDs. Not what I was hoping for but it's good with those standard PIDs. Not sure it's worth the price for MPH, Temp, Voltage, and RPMs.

I wanted CS2 to get eyes on my trans temp in my 1997 Ford Powerstroke XLT when I am hauling my camper. When the product arrived (a couple of days before I was expecting) I hooked it up to my computer per the instructions. One easy to follow download and twenty minutes later it was ready to go into the truck. I went out and plug it in (note: the OBDII port on my truck had a black cover on it and was located on the passenger side of the transmission hump under the dash) it would not power up. Hit the trouble shooting guide and it said check the cigarette lighter fuse. Bingo that was the culprit. For reference on my truck it is the #16 fuse which is the fuse in the upper most right hand corner of the fuse box under the steering wheel. So far I have been happy with the product. I have eyes on the trans tempt and new goal to see my truck produce 20lbs of boost (note the CS2 insight is only a monitor and will not help me get closer to this goal but it will let me see it when it happens). I was also pleasantly surprised with how stout the window mount was for the unit. It solid and holds the unit steady allowing you toggle threw the menus with one hand.

It's ok but theres alot better tuners out there this didnt even have a 93 octain tune so my suggestion is pick a different tuner

Easy plug and play 87 octane tune gives better throttle response and shifts reprogrammed the speed limiter a bigger speed on a Chevy Avalanche and it worked perfectly plug and play install took 10 minutes which was mostly running the cable to the OBD port

I love it and the customer service is the best I’ve ever seen

Just got programmer installed with dash pod, I haven't driven for any amount of time with the programmer running, but the programmer was easy to set up. It has a ton of functions to customize programming, I'm looking forward to using for towing 33 ft fifth wheel. The installation was fairly easy on an 03 GMC Sierra.

It works as promised... our water supply never froze during subfreezing temperatures