Most Popular Board/Ski Lock for 2017 Chevrolet Cruze

Great product at a great price. Fit an adult snowboard, two sets of adult skis (one set stacked, one set side by side because of how close the bindings were to the roof), and a set of youth skis. Fit snug. Only got up to about 73mph on the highway, but no issues. Some normal fluttering on the snowboard/skis. If you have a torque meter to tighten the bolts that's ideal but I didn't. I just got them snug enough to where I pulled back and forth on the rack and it didn't move.

Works awesome with the snowboards, easy to attach/detach, and durable. Locks and holds fine, initial ordering was confusing and hard to figure out since it’s not a package, and had to get individual components. Rhino rack could definitely improve that! Otherwise it would be 5 star.

This rhino product was the perfect solution for me. With a roof rack nearing capacity, I still wanted an accessory for my fishing rods AND ski’s. This rhino product filled that need! Super easy to install in the T-track. Thanks agan!

Last year I purchased Rino ski racks from etrailer and they work great . The hardware fit my roof racks and all the fittings are tight. Ordering was easy. Shipping was fast and I even got a follow up personal email from George a year later asking how I liked them - which was impressive! I would definitely recommend etrailer as an honest and good outdoor gear company!

Decent rack for the money. The locks are a bit finicky due to the metal/composite combination. They definitely require graphite lubricant regularly. I've only used it with 2 pair of skis and it works well.

Howzit etrailer.com & staff. the rack itself is sturdy and more aero than comparable units. For my 2017 Subaru Crosstrek (OEM) Aero Bars, it was necessary to shim the (rear) lower/leading edge clamp assembly with two 1/8” x 1.5” x 1.5” (EPDM) rubber pads. The bars are shaped like a wing – and these shims helped to level the rear rack with the one in front. Overall - it looks very clean and functional. I might screw on some rubber ends over the ends of the mounting bolt to complete the project. Time to make some turns. Thank you!!