Video Transcript for The Low-Down on the Replacement Auger Bearing for Meyer or Swenson Tailgate Salt Spreader

Hi there. I'm Michael with etrailer.com. Today, we're going to take a quick look at this replacement tailgate salt spreader, auger bearing. This is going to replace the auger bearing for your Meyer or Swinson, tailgate salt spreader. This is going to be a comparable to the Meyer Part Number sixty-one-four-sixty-five or the Swinson Part Number zero-four-zero-eight-zero-zero-zero-five-zero-zero. This is going to allow your bearing to rotate smoothly, and you can see we do have the two screws here that will help to keep the pin in place.

We have the three mounting holes here. Also have the grease Zerk there, for lubrication. Makes it easy to hook up and lubricate. The diameter here, our inner diameter is right at one and a quarter of an inch. The distance between our mounting holes here.

If we measure from the inside corner, looking at right about, two and a half inches. If we measure to the outside corner, one outside corner to the other outside corner, we'll call it three and five eights. This is made here in the USA, so you can trust it's made to the high quality standards that we've come to know and trust, for products that are made here in the U S. And so if you are needing to replace that auger bearing for your tailgate salt spreader, this is going to be what you need. That's going to complete our look for today.

Again, I'm Michael with etrailer.com. Thanks for watching..