Replace 1 worn or damaged backing plate on your single-axle trailer fender. Backing easily blocks water and road debris from hitting the side of your trailer.
Features:
Specs:
Note: Backing plates are not to be used for mounting your fender.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody. Andy here with etrailer.com. Let's take a real quick look at this backing plate for your single axle trailer fender. Now this replacement backing plate is going to prevent water and road debris from hitting the side of your trailer. This is fabricated of steel, so it's gonna weld onto your single axle trailer fender. As you probably know, backing plates are not to be used for mounting your fender.
Let me give you some measurements here. Measuring this corner to corner, we're pretty close to 30 inches. Technically we're closer to 30 and a half inches at the length corner to corner, height, we're sitting right at a foot and this is has a radius of 16 inches. It's probably a good idea to wear gloves when handling this 'cause the corners are definitely sharp and I could see where you might cut your fingers a little bit here if you're not careful. So you are going to get this one backing plate.
And so if you need more, just change the quantity on your order to the number that you need. But I think that's gonna wrap up our quick look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.
.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.