Exhaust Rattles After Installing Curt Hitch C11302 On a 2013 Nissan Juke
Updated 09/17/2019 | Published 09/15/2019
Question:
Exhaust rattle is awful below 1000 rpm. What is the best way to stop the rattle. Muffler seems pretty smug against hitch and I am hesitant to bend the post to the muffler because it might be a lot of bending.
asked by: Joe
Expert Reply:
It sounds like you already know what you need to do but if the exhaust is rattling after installing the Curt Trailer Hitch Receiver part # C11302 on your 2013 Nissan Juke there is really only one solution for this and that is to bend the exhaust hangers away from the trailer hitch. I will say however that this usually does not require any extensive bending as an 1/8" is enough to stop the rattle in most cases but I recommend you just do little by little making sure to start the vehicle and check each time that way you don't go too far. The hangers can be bent using any sold piece of metal that you can wedge between the hitch and hanger.
I have attached a help article on this process for you.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Can Hanging Bike Rack with Adapter Bar Be Used with 80 Lb E-Bike
- Q&A: Electric Fat Tire Bike Rack Recommendation for 1-1/4 inch Hitch
- Q&A: Ball Mount for Use With Curt Class I Trailer Hitch Receiver # C11302 for Nissan Juke
- Q&A: Differences Between Draw-Tite # 24892 and Curt # C11032 for 2012 Nissan Juke
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Maximum Tongue Weight Capacity for 2018 Nissan Rogue
- Q&A: Why Doesn't Draw Tite Hitch # 24907 Fit 2015 Nissan Sentra SR