How is a Drinking Water Hose Different from a Garden Hose

Question

Question:

How is a drinking hose different from a garden hose?

asked by: Duane

0

Expert Reply:

The difference between a garden hose and a drinking water hose such as # CAM22823 is the materials and ratings each is made of. Some hoses have materials that contain lead or other materials that are not safe for consumption. A drinking water hose does not have those materials and so it can be rated for potable water.

expert reply by: Michael H

0

Answer 1

For your 2018 Thor Synergy, I recommend taking a look at the: -Advent Air Replacement RV Air Conditioner for Dometic Setup w/ Start Capacitor #ACDOM135 for a white unit, or if you are wanting to stick with black you can use #ACDOM135B. These units…

view full answer...

Answer 2

Sure thing! To replace your Dometic A/C, I recommend taking a look at the: -Advent Air Replacement RV Air Conditioner for Dometic Setup w/ Start Capacitor #ACDOM150 for white, Or the, -Advent Air Replacement RV Air Conditioner for Dometic Setup w/…

view full answer...

Answer 3

The only difference between the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - GM #3025-P and the #3015-P is where the red wire is installed on the connector. The best way to determine which is the correct harness for your 2002-2003…

view full answer...

Answer 4

We have reached out to TireMinder in the past about their sensors, like what is included with the kit #TPMS-TRAILER you referenced, being used for boat trailer applications. While they did say that the sensors can be submerged, they did recommend not…

view full answer...

Answer 5

From the center of the shank to each end of the base of the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W is 18 inches. The entire length of the base is 36 inches.

view full answer...

Answer 6

The slots on the top of the fifth wheel rail adapter part #DM6140 are 29 inches apart for the outside slots and 20-1/2 inches for the inside rails. Typically rails will have a third set of slots that are 10 inches apart.

view full answer...

Answer 7

The Demco 5th Wheel Base Rails Adapter for B&W Turnoverball Gooseneck Hitches #DM6140 has the measurement for standard 5th wheel hitches of 22 inches from the center of the front rail to the center of the back rail. I've attached a photo to…

view full answer...

Answer 8

On the display of the Tireminder part #TPMS-TRAILER there won't be an alert or alarm that goes off if the sensor battery dies but there will be a blank display for that tire so you'd know that the battery had died.

view full answer...

Answer 9

From the center of the post that installs in your B&W Gooseneck Hitch to the forwardmost (towards your cab) part of the B&W Companion #BWRVK3400-5W that you referenced is 15". You'd have to measure forward 15 inches towards the front…

view full answer...

Answer 10

Yes, if you wanted to use the TireMinder TPMS for Dual Axle Trailers #TPMS-TRAILER in the way you described you certainly could. At any given time you'd have just the two tires of either trailer you are towing displaying it's pressure on…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

How is a Drinking Water Hose Different from a Garden Hose

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching