4-Way Extension Wire Recommendation for Bully Dodge Ram Hitch Cover # CR-007D

Question

Question:

I just bought the bully hitch light cover It is a cr-0070. The connector is to short for my dodge ram 2015. What can I use for a extension.

asked by: Rob W

0

Expert Reply:

Best option for a 4-way extension for use with the # CR-007D would be the part # 9653P. This is a 12 inch long extension that will give you just enough extra wire without adding too much wire.

expert reply by: Jameson C

0

Answer 1

The Spectro 4-Pole 12-Inch Car and Trailer End Loop #9653P is a perfect solution for cases where trailer wiring is just a bit too short. We also offer a 4-foot #HM47115 from Hopkins.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Hello Paul, thanks for reaching out. The inside dimension of the Curt Heavy-Duty Dual Ball Attachment for Weight Distribution Shanks #C29NR is 2". It will work with any standard weight distribution shank. I edited a picture to illustrate.

view full answer...

Answer 6

Hey JD, The Weigh Safe Hitch w/ Built-In Scale for 2.5" Hitch #WS88RR uses hitch pic lock #WS54CR, which has a shear strength capacity of 45,000lbs according to Weigh Safe.

view full answer...

Answer 7

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Carl! How much does the Weigh Safe weigh? With all of the parts put together the #WS88RR weighs 35-1/2 lbs. If you need anything else don't hesitate to reach out in the comments below.

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Dallas, the distance from the mounting bracket of the Dexter Jack #DX72CR out to the furthest point out opposite on the pump enclosure measures 10.4 inches. Please enjoy my crude dimensional drawing and let me know if you have any other…

view full answer...

4-Way Extension Wire Recommendation for Bully Dodge Ram Hitch Cover # CR-007D

Products Referenced in This Question

Continue Researching