Which Wires of Bargman #84 Series Stop, Tail and Turn Tail Light # 34-84-008 Go Where on a Trailer
Products Featured in This Question
Question:
Nice video, but...I want to see how Brake, Turn, Signal, And Running light is wired. How does it differ for left driver side and right passenger side. Are these LED.? Well. I wonder about putting LED stop-turn-signal-reverse on my 5th wheel camper 2007, 29 ft, Keystone Challenger. No reverse lights or Back-Up lights on it now. Regards
asked by: Bill B
Expert Reply:
I attached a picture that shows where each of the wires of the Bargman #84 Series Red Stop, Tail and Turn Tail Light # 34-84-008 would wire to a trailer.
The left and right side assembly would wire up the same way. Only difference is that each side would get the stop/turn signal of it's respective side run to it. So the driver side would get the driver side stop/turn and the passenger side would get the passenger side stop/turn.
To add a reverse light to your trailer you would need to run wire back from the reverse light circuit of your trailer connector to each assembly. You could run one wire that tees off and goes to each assembly.
For wire you could use the part # 12-1-1 that is sold by the foot and then for butt connectors # DW05745-10.
The center pin of your 7-way will be for the reverse lights.
