2007 Ford Edge Roof Racks

Features:

These multipurpose, galvanized steel crossbars supply the backbone for your aftermarket roof-rack system. Bars provide stability to your rack system and carry the accessories that secure your gear. Round design fits all Yakima towers.

Installation Notes:

Maximum allowable weight load is 100 lbs

The factory luggage carrier may interfere with the Yakima rack

When open, sunroof may interfere with some accessories

Caution! Check clips after installing. Grab each clip and try to pull them hard away from your vehicle. If the clip moves, tighten the adjustment post. If the clip still moves, recheck your measurements between the towers and adjust if necessary. Check clip again

Loads limited to Skis, Bikes, Boats, Gear Baskets, SpaceCadet 15s, Platinum/BlackTop 16s, and SkyBox/SkyBox Pro 16s. No long loads that cannot be tied down at the ends

Long loads will prevent rear hatch from opening

Roof mounted antenna may need to be removed to prevent interference with long loads, boxes

This kit fits over factory racks

Features:

Attach these premium, aluminum bars to Thule roof-rack feet to create a sturdy, stylish, roof-mounted rack that is supremely quiet and aerodynamic. Pivoting endcaps let you easily slide on T-slot-mounted accessories.

Installation Notes:

Most of Thule’s roof mount bike carriers (except for the TH513 and TH594XT) will require the use of an adapter to allow the carriers attach to the load bars. For more info see bike carrier product page.

Due to the position of the rack, some boxes or accessories may interfere with full opening of the rear hatch or tailgate

Features:

These steel load bars attach to Thule roof-rack feet to create a sturdy, convenient roof-mounted rack. Durable plastic coating resists corrosion and provides cushion for your load. Accomodates accessories that clamp around bars.

Installation Notes:

Due to the position of the rack, some boxes or accessories may interfere with full opening of the rear hatch or tailgate

Because of the vehicle and rack limitations, the Hullavator (# TH897XT) cannot be used

Features:

Black, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your naked roof. Elliptical bars are aerodynamic and feature built-in channels to accept slot-mounted and clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Roof rack is not intended for off-road use.

Features:

Black, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your vehicle with a naked roof. These strong, durable, Euro-style square bars install easily and work with most clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Roof rack is not intended for off-road use.

Features:

This load bar system is designed to be mounted directly onto your vehicle's factory installed raised side rails. 58" load bars and locks are included to complete the roof rack.

Installation Notes:

Due to the position of the rack, some boxes or accessories may interfere with full opening of the rear hatch or tailgate

Because of the vehicle and rack limitations, the Hullavator (# TH897XT) cannot be used

Features:

Silver, lightweight aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a roof rack for your naked roof. Elliptical bars are aerodynamic and feature built-in channels to accept slot-mounted and clamp-on accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Roof rack is not intended for off-road use.

Features:

Economically priced roof rack clamps to your vehicle's elevated, OEM side rails. The square, steel crossbars can accommodate a variety of accessories such as bike racks, ski carriers and cargo baskets. Included locks secure the rack to your roof.

Features:

Silver, heavy-duty aluminum crossbars are paired with locking Rhino-Rack 2500 Series legs to create a ladder rack or roof rack for your vehicle's naked roof. Sturdy, square bars have built-in C-channels for mounting contractor-grade accessories.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Roof rack is not intended for off-road use.

Features:

These low-profile, aerodynamic crossbars clamp to your vehicle's raised factory side rails to create the quietest style of roof rack on the market. The locking aluminum bars provide a from-the-factory look and have built-in slots for accessories.

Installation Notes:

Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack

Any load/mount extending beyond the rear hatch seam may cause interference

Features:

Equip your vehicle with the quietest crossbar style on the market and carry a ton of cargo with the Whispbar Through Bar extended-length roof rack. The locking, aluminum bars mount with a custom fit kit, and they have built-in slots for accessories.

Installation Notes:

Any load extending over the windshield (except luggage boxes) must be secured to both the front and rear of the vehicle, in addition to the rack. The total weight of the racks and loads must not exceed Yakima's weight limit for that vehicle's factory rack

Any load/mount extending beyond the rear hatch seam may cause interference

Clamps onto raised roof rail.

Features:

This locking, removable roof rack mounts quickly and easily to your vehicle's raised OEM rails. It keeps a low profile with its unique elliptical design. Lightweight aluminum crossbars have T-slots for mounting Rola carriers and accessories.

Features:

Economically priced, removable roof rack clamps to your vehicle's naked roof. The square, steel crossbars can accommodate a variety of accessories such as bike racks, ski carriers and cargo baskets. Included locks secure the rack to your roof.

Installation Notes:

This system utilizes a clamp-style attachment to secure itself onto your vehicle's roof.

Hold the hook while tightening the mechanism.

Features:

Quick and easy to install, this kit is great for adding an aftermarket roof-rack system to your vehicle with raised, factory side rails. Includes 4 rail-grabbing legs; 2 black, 50" long Sportz crossbars; and 4 locking endcaps.

Features:

This locking, removable roof rack mounts easily to your vehicle's naked roof with custom-fit clips. Its unique, elliptical design gives it a low, aerodynamic profile. Aluminum crossbars include T-slots for mounting Rola carriers and accessories.

Features:

Quick and easy to install, this kit is great for adding an aftermarket roof-rack system to your vehicle with raised, factory side rails. Includes 4 rail-grabbing legs; 2 silver, 50" long Sportz crossbars; and 4 locking endcaps.

Features:

Low-profile, aerodynamic crossbars strap to your vehicle's raised, factory side rails to create a super-strong and ultra-quiet roof rack. The aluminum bars perfectly complement your roofline and have built-in T-tracks for mounting accessories.

Installation Notes:

Most of Thule’s roof mount bike carriers (except for the TH513 and TH594XT) will require the use of an adapter to allow the carriers attach to the load bars. For more info see bike carrier product page.

Due to the position of the rack, some boxes or accessories may interfere with full opening of the rear hatch or tailgate

Features:

The aerodynamic Whispbar Flush Bar pairs a factory look with the quietest crossbar style on the market to form the ultimate roof rack for your vehicle. These locking, aluminum bars mount with a custom fit kit and have built-in slots for accessories.

Installation Notes:

Any load extending beyond the length of the roof (except luggage boxes) must be secured to both the front and read of the vehicle, in addition to the rack.

Due to crossbar spread limitation, Kayak Stacker is not recommended on this application

Canoes must be 14 feet or less on this application

Clamps directly to edge of roof under the doors.