Videos
for Hand Tools
Help Articles
for Hand Tools
Expert Answers
for Hand Tools
The Firestone In-Cab Pressure Gauge #F2196 will work with the AirLift systems. If you can tell me the part number of which AirLift kit you have I can try and help you with that system if you'd like.
view full answer...Based on the GVWR of your 2019 Jayco North Point 315RLTS it does seem like you have 7k axles. I recommend verifying this information to be sure. These axles typically use the #14125A outer and #25580 inner bearing found in the Timken #TMK92VR.…
view full answer...The socket needed for the Fastway e2 is the 1-7/8" 12pt Thin Walled Socket #ALL643216.
view full answer...Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item #ET7WK. This includes a 7-Way connector,…
view full answer...Both the Air Lift LoadLifter 5000 Air Helper Springs #AL57234 and Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88234 are a fit for your 2019 Ford Ranger, and the difference between the two is really only what…
view full answer...Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
view full answer...You can have a 2-5/16 inch hitch ball on either a 1 inch or 1-1/4 inch shank. The nut on a hitch ball with a 1-1/4 inch shank takes a wrench with a 1-7/8 inch socket. A hitch ball with a 1 inch shank will take a wrench with a 1-1/2 inch socket. You…
view full answer...No, it does not. The hitch ball does not come mounted on the Equal-i-zer Weight Distribution item #EQ37101ET. You will need to use a 1-7/8" Thin walled socket like item #EQ70-00-4800 to get it installed.
view full answer...Yep! The 1-7/8" 12pt Thin Walled Socket #ALL643216 does work with the e2 Fastway round bar weight distribution systems. This socket costs considerably less than the Equal-i-zer socket and works just as well so it's what we normally…
view full answer...Mixing and matching the brackets and air springs isn't really recommended but you might be able to get a combination to work. If I were you I would just put the complete #AL88288 kit on since that would fit properly and there wouldn't be any…
view full answer...All of the brake hoses, including the main brake line, are made of rubber on the 20 foot Kodiak Hydraulic Brake Line Kit - Tandem Axle #20TA-BLKIT. The hoses on the #20TA-BLKIT also have brass fittings with stainless steel flares.
view full answer...EZ Lube axles like the item #T3584F-EZ-8974 come from the factory with just a little bit of grease in the bearings. The first time you use the EZ Lube feature to fill the axle, it will take a lot of grease. You will probably use 3/4 to a full tube…
view full answer...