2012 Ford F-350, 450, and 550 Cab and Chassis BOLT brand vehicle and hitch locks

From the top of the B and W Tow and Stow part #BWTS10043B down to the bottom of the unused ball when it is in it's lowest position measures 14 inches. The 7 inch drop version part #BWTS10040B instead has this distance…

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the…

Here is the wiring diagram from SeeLevel for the Monitor #SE94VR. I hope this helps you clear things up and get it working.

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

I believe you are referring to something like the Pop & Lock Power Locking Handle for Truck Caps and Hard Tonneau Covers #PAL9555 which adds a power lock to the ARE camper shell on your 2016 Ford F-250. The only other…

Hi John, I'm sorry you weren't given a set of instructions to go along with your SeeLevel RV Holding Tank Monitor #SE94VR. I've attached a diagram below showing that…

The TireMinder i10 TPMS #TM38FR refreshes every 6 seconds. You will get a visual and audible alert when the monitor receives the signal from your tire sensor is either below your pressure or the temperature exceeds the maximum setting.

From the top of the shank to the bottom of the vertical section of the B&W Tow & Stow 2-Ball Mount #BWTS10040B measures 10". Then with the…

The Curt Trailer Hitch Receiver #C14012 you looked at fits the cargo van and passenger wagon models of the 2020 Ford Transit T350. The extended high roof won't impact fitment so you will be able to use this hitch on your…

That's a good question, and there's an interesting reason why there are the long holes on the side of the etrailer Magnetic Hitch Receiver Reducer Sleeve - 2-1/2"…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being…