Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
It is possible you can use the Timbren Suspension Enhancement System #TFR350SDJ (which is made for a Ford F-350) on your 2020 Ford F-250, but we have never done this and it hasn't been tested so I just can't guarantee a good fit. There are…
view full answer...Porpoising (bouncing like you described) and sway are both commonly caused by the same thing when towing and that is not enough tongue weight for the trailer relative to the total amount of weight the trailer weighs. You need the tongue weight to be…
view full answer...Yep, it sure does; the Timbren suspension enhancement you asked about is a fit for your 2022 Ford F-350 Tremor. The correct part number is the following: - Timbren Suspension Enhancement System #TFR350SDJ The Timbren #TFR350SDJ are a really smart…
view full answer...Both the ProPride 3P part #PR57QR and the B and W Continuum part #BW78FR allow backing up and work extremely well but since there isn't a ProPride system that would be ideal for the tongue weight of your Winnebago Minnie FLX2306 I would go with…
view full answer...The drop spindle model you mentioned, part #A35RD545E would be used over the straight spindle model, part #A35RS545E if you wanted a lower deck height on your car trailer. Since you are most likely already using ramps, I cannot see how you would…
view full answer...First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…
view full answer...The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package, #BWRVK3775 has a shipping weight of 251 lbs. A small portion of this will be packaging for shipping, it ships as a single unit.
view full answer...Your Kaufman Trailer with the 7,000lb Lippert axles will use a Bearing Kit #BK3-200 to rebuild the axles. This will be all you need if the brakes and hubs are still in good condition. If the brakes are worn you can replace them with the Dexter…
view full answer...If the trailer has electric brakes, you will need a brake controller to actuate them. GM didn't start offering a factory brake controller until a few years later. I would recommend the Tekonsha Prodigy P2, part #90885. The Prodigy P2 is one of…
view full answer...When it comes to choosing between the Curt TruTrack Weight Distribution System w/ Sway Control #C17499 and the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control #EQ37100ET you'll want to take a couple of things into consideration: 1.…
view full answer...You are correct, it is the Yakima Landing Pad 1 part #Y00221 that is compatible with the Truxedo Elevate TS rails.
view full answer...Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
view full answer...



