Go Power RV Inverters - Pure Sine Wave Inverter - 34278156 Review
Products Featured in this Video
Review of Go Power! RV Inverters 34278156
Speaker 1: Today we're gonna take a look at the Go Power 12 Volt 2000 Watt Industrial Pure Sine Wave Inverter. Now this inverter will convert incoming DC battery power to usable AC household power wherever you go. This industrial pure sine wave inverter gives you an exact replica of AC power for your portable electronic equipment. This is perfect for large loads like a microwave or other medium size electronics, and this'll run any device in the wattage range without interference. It is a light weight, low profile design, just to give you an idea on the ends here, show you what they have.Right here it has your on and off switch, here you have the dual ground fault AC outlets. Over here you'll have a power saver function switch, next to it is a power saver adjustment mode.
Right below it you'll see three LED lights, those are your function LEDs. On the other end you'll have your, right here you'll have your remote controlled port and terminal. Down here is your chassis 00:01:00 ground, and then right here is your DC input connectors. Now I have attached the covers to it, just to show you how those install, but this is where your battery cables will connect to.Now this does have a full overload protection. It is compatible with 12 volt systems, has a continuous output power of 2000 watts, peak surge power of 3500 watts, the AC output voltage is 100 volts to 120 volts, input voltage range is 10 and 1/2 volts to 16 and 1/2 volts DC, and the AC output wave form again is the pure sine wave.
Maximum efficiency on this is 92% battery drain with no AC load is less than or equaled to 1.8 amp. Does offer a low battery alarm, a low battery shutdown, does include everything here on the table. The inverter itself, the two ring lugs that'll be used to attach your battery cables to the terminals here on the inverter. As I mentioned, the DC terminal covers which I've already installed on here, and a nice users manual that'll describe how to connect everything and how to use it.Weight on this unit is about 11 and 1/2 pounds, and a few dimensions on this, the length from this end all the way to this end including the terminal covers is gonna be 17 and 7/16th inches long, the width on it is gonna be 9 and 3/4 inches wide, and the total depth from the bottom to the very top is 3 and 1/4 inches deep. That should do it for the review on the Go Power 12 Volt 2000 Watt Industrial Pure Sine Wave Inverter..
Info for this part was:
Installed by:
Jeff D
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.