2020 Jeep Cherokee Vehicle Tow Bar Brake System

Features:

This portable unit gets you smooth braking without a complex installation. Senses the RV braking and applies the brakes proportionally. Easy to swap between multiple towed cars: settings adjust for safe, even braking for any size car.

Features:

This portable unit gets you smooth braking without a complex installation. Senses the RV braking and applies the car's brakes at an intensity preset by you. Easy to swap between multiple cars; settings adjust for smooth braking for any size car.

Features:

Get fully proportional braking with a system that never has to be removed, replaced, or reset. Actuator installs out of sight and remains virtually invisible when your car isn't being towed. Controller also works as a trailer brake controller.

Features:

COMING SOON! Adds braking capabilities to your towed vehicle when flat towing behind an RV. Simple one-button interface automatically positions itself in the vehicle.

Features:

COMING SOON! Adds braking capabilities to your towed vehicle when flat towing behind an RV. Permanently installed design means no user setup after installation.

Installation Notes:

The stop light switch kit listed is a requirement for proper usage of this braking system.

Some models of this vehicle may use Mortorq® fasteners. If your vehicle has these types of fasteners, you will need a PFMTS2E bit to remove them which can be ordered through a Snap-On dealer.

Tech Tip:

The brake pedal arm has a flange on the bottom which makes it too wide for the included hardware to attach the brake pedal clamp. You will need to locally purchase two #10-32 x 2 inch bolts and nuts.