Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Dwayne! To find the right slide-out topper length you need to get the flange to flange measurement on your R-Pod slide-out. See the attached photo. Once you have this measurement you can add it in the comments below and I'll help you find theā¦
view full answer...Hey Tim, welcome back! The MORryde GooseTech 5th Wheel to Gooseneck Pin Box #MR37MV can use 3/8" or 5/16" safety chains. The Gen-Y #GY49GR you were looking at will fit since they run straight through the pin box just like on Gen-Y pinā¦
view full answer...The 6 inches (roughly) is on both ends. So about 12 inches total. There is a little wiggle room if you don't quite have 6 inches when installing a slide-out topper such as #LCV000168105 but not much.
view full answer...Hello Tim, thanks for reaching out. The slide toppers we offer are not meant to be cut or modified. What is the width of your slide out?
view full answer...Hey Dennis welcome back! The Adco Tyre Gard RV Tire Cover item #290-3922 fits 30" - 32" diameter tires. Your ST215/75R17.5 tires measure 30.2" diameter so this cover will fit perfectly so long as you have a 6" or less gap betweenā¦
view full answer...Yes, The Dexter #DX74XR will work as a direct replacement for the Dexter 072-100-01 you were looking at. These are the same length, capacity, spring count, and both use bronze bushings. It looks like the Dexter 072-100-00 uses a weird rubber bushingā¦
view full answer...Hey Erik, It's common for the light on your Furrion stove's knob to stay on if it senses that the oven is on. Since you're clearly not running the oven but it's still on and staying red instead of changing to blue that would indicateā¦
view full answer...Hello Don, It comes with great sadness to tell you that there is not adapters that will work for you to use the Curt Helux #C73RJ with a different pin box number. At this time they are only making it for the Rhino. Let's not give up hope though,ā¦
view full answer...Hey Rob! Weight distribution systems are based off of tongue weight which is 10%-15% of your trailer's total weight so that would put a regular trailer between 12,900 lbs and 1,900 lbs. Since yours is a toy hauler you're not going to getā¦
view full answer...Thank you for all of the details and photos! The Replacement Head #RP58167 and Curt Hitch Ball #C40008 are what you need to complete the 12K system. Since this same head is used for the 12K and 17K systems all you need to do is get two of the 1.7Kā¦
view full answer...Since the trailer tongue weight is so high and you have a 2-1/2 inch trailer hitch, I recommend Strait-Line Weight Distribution system, #RP66075. This system has a tongue weight capacity range of 1,000 to 1,700 pounds. The problem is that you mayā¦
view full answer...The difference between a 2-point and 4-point sway control system has to do with the amount of locations where friction is used on the system to limit and stop trailer sway. A 4-point system like the Equal-i-zer #EQ37120ET you referenced uses frictionā¦
view full answer...