Result: 20400

Hi Richard; the distance between the two #DE46QR mounting holes is 5.8" on center. See the attached picture. Are you looking for a replacement for a specific brand of disc brakes?

Hello Richard, Congrats on the new 2024 Dutchman 36 5th wheel! What is your favorite new feature? Looking to make the swap over to disc brakes, you will not be disappointed. Here is the set-up you will want with the DeeMaxx brakes: - (2) sets of the…

Hi Keith; since it is a tandem axle trailer you only need one DeeMaxx Hydraulic Brake Line Kit #DE57SR. This has everything you need to replace the lines on your current setup. For replacement calipers/rotors/hubs (so really a complete replacement)…

Hi Tom, I've attached the wiring diagram for the Hydrastar Electric Over Hydraulic Actuator Kit for Disc Brakes #HBA16-252-82 below as well as a video I made where I'll walk you through the installation process.

Based on the photo and information you provided, I can tell you have 12 x 2 inch Dexter brake assemblies for 5.2K axles, for which the Electric Trailer Brake Kit #AKEBRK-7-SA will be an excellent replacement. These are self-adjusting brakes so they…

Brake calipers are typically installed so they point toward the back of the trailer, but it is okay to install them pointing up or toward the front of the trailer. The important thing to consider when installing the calipers is to make sure at least…

Hey Aaron, the DeeMax Disc Brake kit part #DE28YR that you referenced is designed to attach to a brake mounting flange that is on the trailer spindle. If your trailer was missing that the correct flange for a 6k axle would be the part #4-44-1.

Good question, Dale! It took me a few minutes of back and forth between the two Hydrastar disc brake kits to figure it out, but the only difference is that #HYD44VR uses all Dacromet coated parts and the #HYD74VR uses mostly Dacromet coated parts,…

The correct replacement for your Klauber K01431B300 slide-out motor is the Replacement Motor Assembly for Lippert RV Slide-Outs - Klauber A-300 Model #LC157511.

The mounting bolt pattern for the Buyers Products 3" I.D. Heavy-Duty Forged 4-Bolt Mount Lunette Ring #337BDB1385 that you referenced is 4-1/2 inches square.

You'll want to connect the black wire to a switch or circuit you can turn on and off for the Red Identification Light Bar with White LED Utility Light item #OPT88FR. If you wire it up like a standard light to a tail light wire the white utility…

To make sure you find the right replacement hubs you can do a couple of things. First check out the bearing and see if you can find the numbers for the bearings either etched or stamped on the side of the bearing. If you can not find the numbers you…