Changing a US Style 7-Way Vehicle Connector to a European Style 7-Way Connector

Updated 11/04/2014 | Published 11/03/2014

Products Featured in This Question

Adapter 7-Pole Round Pins To 4-Pole Flat

(49)

$9.85

2-to-3 Tail Light Converter for Towed Vehicles w/ Incandescent Tail Lights

(172)

$38.14

Question:

Hello, I have a Jeep Grand Cherokee with a US 7 way trailer connector, and I am permanently located in europe and want to be able to adopt this to a European 7 way trailer harness. Is there a convertor or what is the best way to do this?

asked by: Jaanus

Expert Reply:

The European 7-Way does the same thing that the US 4-Way does. There isn't an adapter available because the European 7-Way has separate circuits for nearly every function on each side of the trailer. The US style 4 or 7-Way has combined brake lights and turn signals.

What you will have to do is change over the US style 7-Way to a European one. You will need 1 European style vehicle side 7-Way and one special converter that separates the combined signals to separate ones.

You will need to remove the vehicle side 7-Way on the Jeep leaving the wires. Using a circuit tester such as # ALL640595, identify the left turn signal/brake light wire and the right turn/brake light wire. The left side wire will connect to the yellow input wire on converter # 118158. The right turn/brake light wire connects to the green input wire. White is ground on this converter. The running light wire will bypass the converter.

On the output side of the converter red will be brake lights only, green will be right turn only, and yellow will be left turn only. Wire up the new European vehicle side 7-Way accordingly. On the trailer side, you may have to run jumper wires for the running lights since the vehicle side will only have one running light wire.

expert reply by: Michael H