How to Bypass the Integrated Brake Controller of a 2014 Ram 3500 and Install a P3

Published 09/19/2014

Products Featured in This Question

Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In

(264)

$21.07

Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional

(6654)

$159.94

Question:

Can Prodigy P3 be installed on 2014 Ram 3500 that has a factory installed integrated controller

asked by: Bill M

Expert Reply:

You can bypass the factory brake controller on a 2014 Dodge Ram. To install an aftermarket controller you will need to disconnect the integrated trailer brake module (ITBM). Doing so will turn on a warning lamp in the dash.

In order to disconnect the ITBM and not get the warning lamp, your local Dodge dealer will have to reconfigure the TIPM (Totally Integrated Power Module), of the truck. Once the TIPM has been reconfigured, and the ITBM has been unplugged, you can use a vehicle specific brake control harness, # 3023-P.

To disconnect the ITBM, you will need to contact Business Center to remove the sales code (XHC). The TIPM will need to be reconfigured. Once the sales code has been disabled you can disconnect the ITBM electrical connector, under the dash, without getting the warning lamp.

expert reply by: Jameson C