Outer Diameter of the Mounting Bracket Tube of the Pro Series Swivel Jack

Question:

I need to replace a bent jack that already has the bracket welded on. I can remove the jack by removing the snap ring and would like to just use the existing bracket for the new jack. The swivel stud pipe measures 2.5inch OD and the female jacks side of the swivel is just a hair bigger. Can you confirm either the ID of the jack side of the swivel joint or the male OD of the swivel bracket side? Thanks!

1

Helpful Expert Reply:

I went out into our warehouse and measure the mounting bracket tube of the Pro Series Swivel Jack part # PS1400300303 and found that the outer diameter of the bracket that attaches to the trailer is 2-1/2 inches. Based on that this jack should work for you.

helpful expert reply by:
1
Jameson C

Product Page this Question was Asked From


Follow up Questions

Similar Expert Q&A Pages

See More Q&A Expert Answers >>