What Is The Distance From Pin Hole To The End Of The Hitch On The DT58KV?
Updated 12/29/2025 | Published 12/01/2025
Question:
What is the distance between the pin hole and the end of the hitch on the draw tight hitch? I need a minimum of 2” for my Thule bike rack.
asked by: Robert K
0
Expert Reply:
Hey Robert,
I ran out to our warehouse to get that measurement for you. From the pin holt to the end of the hitch on the Draw-Tite # DT58KV it is 2-1/2". I attached a photo for you as well to show where I measured.
What Thule bike rack are you using?
expert reply by:
Nick S
0
hitch measurement
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - 2"
- Trailer Hitch
- For Towing
- Class III
- 150 lbs TW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Deciding Between The Curt And Draw-Tite Hitches For My 2021 Subaru Forester
- Q&A: What Does Tire Capacity Difference Between Single and Dual Tires Mean
- Q&A: Can Pullrite 2400 be Used with RotaFlex Cushioned Pin Box
- Q&A: Recommended Wiring to Flat Tow 2020 Jeep Wrangler Behind Motorhome
Nick S.
12/29/2025
Hey Robert, did the 2-1/2" distance on the Draw-Tite hitch give you enough clearance for your Thule bike rack? Knowing how it fit could help others checking their rack spacing too.