How Far Past Bumper of Truck Does Draw Tite Hitch # 41001 Stick
Updated 08/22/2025 | Published 08/15/2025
Question:
What are the bolt hole measurement starting at the end of the reciever tube toward front of pickup?
asked by: Ryan H
0
Expert Reply:
Hey Ryan, it sounds like you are wanting to know how far the Draw Tite hitch # 41001 would stick past the bumper of your truck when installed. It actually doesn't stick out past the rear bumper and instead it is recessed. The center of it's hitch pin out to the rear bumper edge measures 4 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-E-Loader Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Q&A: Will Draw-Tite Hitch Fit on a 2018 Ford F-150 with a Factory Hitch
- Q&A: Trailer Hitch and Wiring for 2022 Ford F-150 Without Factory Tow Package
- Q&A: Side Plate and Bolt Hole Spacing Measurements for Curt Trailer Hitch # C14082
- Q&A: Dimensions of Hitches for a 1997 Chevy C/K 3500 Cab and Chassis
- Q&A: Recommendation for a Class III or IV Trailer Hitch to fit a 1986 Chevrolet K-20 Pickup
- Q&A: Trailer Hitch Receiver Fit For 1965 Ford F-250 With Custom Bumper
- Q&A: Trailer Hitch Recommendation for a 1966 Ford F-100 With a Standard Bumper
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Hitch Installation Tips
- Article: Towing a Trailer? Let's Talk About Brake Controllers
Ryan H.
8/22/2025
Not exactly. I want to know what the dimensions are from the end of the receiver tube to and through first mounting tab and spacing between the rest of the tabs