Can Flat Backside of Single Axle Trailer Fender part # F008541 be Used as Attachment Surface
Updated 09/14/2025 | Published 05/20/2025
Question:
these fenders: Single Axle Trailer Fender w Top Step - Style C - White Plastic - 8 to 12 Wheels - Qty 1 Will attaching the flat back side of the fenders support the fender? I do not want to use brackets and I will not be using it as a step, but just as a fender.
asked by: Barry
0
Expert Reply:
Hey Barry, if you wanted to just run mounting hardware through the flat panel on the backside of the single axle fender part # F008541 you certainly could since you said you just wanted to use this as a fender and not also as a step.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Single Axle Trailer Fender w Top Step - Style C - White Plastic - 8" to 12" Wheels - Qty 1
- Trailer Fenders
- Top Step
- 10 Inch Wheels
- 12 Inch Wheels
- 8 Inch Wheels
- 7 Inch Wide
- 21-1/2 Inch Long
- Plastic
- Bolt-On
- For Single-Axle Trailers
- White
- Fulton
more information >
Continue Researching
- Q&A: How Do The etrailer Single Axle Trailer Fenders Install?
- Q&A: Which Grease Should be Used with a Dexter Trailer Axle
- Q&A: Adding Trailer Fenders with Top and/or Side Steps to a 2012 Triton LXT Jetski Trailer
- Q&A: Diameter of Threaded Portion of LaSalle Bristol 34433793W Sink Drain Assembly
- Q&A: How To Determine The Replacement Parts For Boat Trailer Hubs
- Article: Trailer Lighting Requirements
- Q&A: Recommended Roof Rack for a 2023 Chevrolet Bolt EV w/ a Naked Roof
- Q&A: Bearing Kit for EZ Loader Part Number 300-020885
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Tire Sizing
Jameson C.
9/12/2025
Hey Barry, did mounting the fender directly without brackets work out for you? I'm curious to know because it could help others considering a similar setup.