Will Yakima RailGrab Fit 2025 Toyota 4Runner Factory Rails
Updated 09/29/2025 | Published 05/07/2025 >
Products Featured in This Question
Question:
I recently purchased 2025 Toyota 4Runner and have the rail grab towers from previous car. Will the pin adapters fit my factory rails? I checked and it has the little holes for the pins or at least it looks like that’s what they are far. Will these work?
asked by: Chad D
Expert Reply:
Hello again Chad; the Claws with Pin Adapters for Yakima RailGrab Roof Rack Towers # Y8880201 are designed for certain Audi, Kia, and Jeep models. The RailGrab has been discontinued and there are no kits that allow them to fit the rails on your 2025 Toyota 4Runner.
If you want to install the RoundBars like the ones I just responded to you about you can use the Yakima SkyLine Roof Rack for Fixed Mounting Points - RoundBar Crossbars # Y23FB. This comes with 48" crossbars, the towers, landing pad, and RoundBar adapter. If you would like a different roof rack style let me know in the comments down below.
Product Page this Question was Asked From
Claws with Pin Adapters for Yakima RailGrab Roof Rack Towers
- Accessories and Parts
- Roof Rack
- Tower Parts
- Claws
- Yakima
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Roof Rack
- Q&A: How to Determine Which Yakima Railgrab Claw is Needed to Fit Vehicle
- Q&A: Ball Mount Recommendation for Curt Hitch for 2008 BMW 335xi
- Q&A: Will Removing the Nuts Cause Bumper to Fall Off When Installing Trailer Hitch on 2008 BMW 328xi
- Q&A: Will the Thule Hullavator Pro # TH898 Install on Yakima Round Bars
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: All Replacement Parts for a Yakima Railgrab Tower
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Q&A: Curt Trailer Hitch vs. Draw-Tite Trailer Hitch on 2020 Ford Escape
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)



Robin H.
9/29/2025
Hey Chad, did you decide to go with the Yakima SkyLine Roof Rack for your 4Runner, or are you considering a different style? I'm curious to know how it worked out for you, as it could help others with similar setups.