Do Additional Holes Need to be Drilled into Draw Tite Hitch 75713
Updated 09/26/2025 | Published 04/25/2025
Question:
Have 2014 special service durango it has 3 bolts not 2 on each side bought hitch 7513 which had holes for 2 bolts do leave out middle bolt or drill extra hole?
asked by: Dennis B
0
Expert Reply:
Hey Dennis, with the Draw Tite hitch part # 75713 that you referenced you only have to use the bolt holes that match up with the hitch. If there's a third hole on your frame you do not need to also use it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 900 lbs TW
- 6000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 900 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability of Stealth Hitches Plug and Play Wiring Harness for 2019 Land Rover Discovery
- Q&A: Installation Instructions for Curt C31033 Front Mount Receiver for 2015 Jeep Grand Cherokee
- Q&A: Can the Curt Front Mount Trailer Hitch Receiver be Used for Recovery of a 2014 Jeep Grand Cherokee
- Q&A: Best Hidden Trailer Hitch Recommendation for 2020 Dodge Durango
- Q&A: Recommended Towing Setup for a 2017 Jeep Grand Cherokee Without Towing Package
- Q&A: Difference Between Square and Round Tube Trailer Hitches for 2010 Honda CR-V
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Is There a Repair Kit for An Atwood 88051 2-5/16" Coupler
- Article: Brake Controller Installation: Starting from Scratch
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: How Much Trailer Can I Really Tow
Jameson C.
9/26/2025
Hey Dennis, did using just the two bolt holes work out for your Durango? I'm asking because your experience could help others with similar setups.