Would Pro Series Jack Work Well on 4,600 lb Trailer
Published 01/23/2025
Question:
I have a 2014 ice castle perch palace with a total weight of 4600 lbs. my front tongue jack broke, what load weight and lift weight will I need to replace this jack? It’s a round mount tongue jack. Also, bonus if you know the lift height for this hydraulic fish house. Thanks for your time.
asked by: Rawson P
Expert Reply:
Hey Rawson, so for a 4,600 lb trailer you'd have about 460 lbs of tongue weight which a 2,000 lb jack like the Pro Series part # PSEA20000103 would work great for. The jacks are rated for what they can lift and support and on a trailer that is the tongue weight. So this jack would have about 4 times as much lifting capacity which means it would be super easy to crank.
We don't have a way to look up the lift height of your fish house unfortunately.
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack - Topwind - 14" Lift - 2,000 lbs
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 14 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Continue Researching
- Q&A: What Powers the Performance Tool LED Safety Flare Set?
- Q&A: Replacement Air Filter for Atwood AirCommand Air Conditioner
- Q&A: Replacement Interior LED Lights For a Liteco 179 Florescent Light Fixture
- Q&A: How to Manually Operate Bulldog Powered-Drive Jack Kit BD1824180100 When No Power is Available
- Q&A: What Weight Capacity of Tongue Jack is Needed for a 4,600 Pound Dry Weight Trailer
- Q&A: Recommended Replacement For A Dometic DOTR12CB RV Microwave
- Q&A: How Does the Roadmaster Tow Bar Wiring Kit # RM-154 Install on a GMC Jimmy
- Article: Performance Chips and Modules
- Article: Best 2020 1/2-Ton Trucks for Towing a 5th Wheel
- Article: Converting Your RV Water Heater to Tankless
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Trailer Hitch Installation Tips
Rawson P.
1/23/2025
Thank you for the reply, however I am looking for a round pipe mount jack. I did get enough information to find what was needed though, thank you.