Is it Required to Use all 6 Bolts to Install the Draw Tite Hitch part # 75120

Published 05/28/2014

Products Featured in This Question

Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"

(36)

$228.87

Plug-N-Tow (R) Vehicle Wiring Harness

(32)

$46.24

etrailer 2-3/4" Rise or 4" Drop Ball Mount Kit - 7,500 lbs

(1375)

$109.91

Question:

I have a draw hitch for a 2003 toyota sienna that requires 6 mounting bolts, 4 are from the existing tow brackets, and then 2 would require drilling holes. I dont want to drill holes, and was wondering because some of the class 3 hitches only require the 4 exisiting holes to mount would it be safe to not use the extra 2 that would require me to drill holes? I would use new bolts and lock washers when installing. It just seems to me that why would it be safe to have some class 3 hitches mount with 4 and some require 6 they are rated for the same weights???

asked by: Bob

Expert Reply:

It sounds like you have the Draw Tite Hitch part # 75120 for your 2003 Toyota Sienna. I can only recommend that you install this hitch per the manufacturer recommendations by using all 6 of the installation points. Otherwise the warranty would be voided.

If you need trailer wiring you would want the Hopkins Harness part # 43475.

For a ball mount, hitch ball, and pin and clip, I would recommend the etrailer Ball Mount Kit, part # EBMK4. This is a kit which includes 2 ball mounts, a 1-7/8 inch ball, 2 inch ball, and a hitch pin and clip.

expert reply by: Jameson C