Troubleshooting a Tekonsha T-One Trailer Wiring Harness That Works Intermittently
Updated 12/22/2025 | Published 09/27/2024
Question:
I installed the T-One vehicle wiring in my 2010 Town and Country about 7 years ago. Now, it will work for a while, but then my vehicle starts fast blinking like the light bulb is burned out. If I disconnect the t-connector, the bulb works fine. What could cause this issue?
asked by: Dan S
Helpful Expert Reply:
It sounds like it could either be a grounding issue, or a wiring issue, Dan. I recommend checking the ground connections and make sure they're good and not damaged. If the grounds are good, and the wiring doesn't appear to be broken, then I believe it's time to swap the harness out with a new one # 118552.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Visible
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Do You Need to Have the RF Controller for Blue Ox Patriot 2 & Patriot 3 Supplemental Braking Systems
- Q&A: Replacement For Slide-Out Motor 130-1146
- Q&A: Replacement for Lippert Awning Part V000592680
- Q&A: Does etrailer Hitch Require Trimming Rear Bumper for Install on 2020 Mazda CX-5
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Hitch and Wiring for 2008 Chrysler Town and Country Carrying Wheelchair Carrier
- Q&A: Hitch And Wiring Availability For A 2025 Kia Sorento Hybrid SX-Prestige
- Q&A: What Does Harness on 2017 Ford Explorer Look Like for Trailer Wiring
- Article: Trailer Hitch Installation Tips
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
Kate F.
12/22/2025
Hey Dan, did replacing the wiring harness fix the fast-blinking issue on your Town and Country? Knowing how it turned out could really help others troubleshooting the same problem.